Filter
Top Products
XDV Direct Vent Gas Fireplace
28
10009383
Log Rear
LG465
Figure 58
Bracket
NOTE: Refer to Figure 57 for bracket and bend loca-
tions.
1. Place log rear. The rear log sits in the firebox at an
angle toward the left over the rear log bracket and
the left side of the burner. (Fig. 57) Set the log on
the rear log bracket. Slide the log to the right until
the bracket lines up with the left side of the notch
on the rear log. Swing the left end of the log toward
the front until it makes contact with the stop bracket.
(Fig. 58)
Stop
Bracket
Rear Log Bracket
Pilot
Bracket
Bend
Front Left
Bend
Front Brackets
FP1607
Fig. 57 Burner brackets and bends.
Left Edge
of Bracket
39XDV
Log Overlay
LG466
Figure 59
2. Place the log overlay. Hold the
overlay with the flat side down
and large cut out for the middle
flame on the right. Set the overlay
on top of the burner toward the
left front inside the stop bracket
on the left end and the bend on
the front left of the burner. (Fig.
57) A slight adjustment may be
needed after placing the front
right log. (Fig. 59)
3. Place the log front right. Hold the
log with the pointed end toward
the left. Place on top of burner
toward the right. Slide the log
toward the front until it comes in
contact with the bracket at the
front of the burner housing behind