Filter
Top Products
11
Radiance Natural Vent Gas Heater
20004409
Pinch
Grommet to
Remove
Snapstat Module
Snapstat Bracket
ST670
Fig. 17 Remove the snapstat and grommet from the bracket
and insert the grommet into the inner shroud.
Slot
Outer
Shroud
Inner Shroud
Slot
ST194
Fig. 18 Position the fan to engage the inner shroud with the
fan bracket slots and secure with sheet metals screws.
8. Route the rheostat wire assembly to the right be-
tween the inner and outer shroud. Run the wire
through the slots at the bottom right corner of the
inner shroud. Some models have the extension wire
assembly attached to the inner shroud.
9. Refasten the outer shroud to the inner duct assem-
bly.
10. Install the snapstat by loosening the front screw on
the inner side of the duct (Fig. 19) slide the snapstat
under the head of the screw and tighten. Connect
the leads to the snapstat. Make sure the snapstat
assembly is mounted straight front to back.
11. Slide shroud assembly over the sides and fasten
the four screws loosened earlier.
12. The rheostat control switch attaches to the left side
of the valve bracket at the front of the stove. (Fig. 20)
• Remove the plug from the rheostat bracket.
• Insert the switch box shaft through the hole in the
back of the right side of the valve bracket, aligning
the locator pin with the smaller hole in that
bracket.
Left Air Duct
Snapstat
ST671
Fig. 19 Install the snapstat and connect the extension wire
terminals. View is with top removed, however, access is
available through the rear when installing fan befoe gas line
connection.
MOTOR
SNAPSTAT
ON/OFF
RHEOSTAT
WHT
WHT
BLK
BLK
BLK
GRN
BLK
POWER
ST196
Fig. 21 #2767 / FK26 Fan wiring diagram.
Retaining Nut
Control Knob
ST347a
Fig. 20 Attach rheostat to left side of valve.
• Attach the control knob to the rheostat shaft.
• Use the wire tie to secure the fan and rheostat
wire harnesses together.
12. Plug the power cord into a standard grounded 110
volt household outlet. If the fan control knob is not
turned to the OFF position, the fan will turn on when
the temperature at the snapstat reaches approxi-
mately 109°F.