Filter
Top Products
1414
Jefferson Direct Vent/Natural Vent Gas Heater
30004177
Assembly Procedures
Failure to position the parts in accor-
dance with these diagrams or failure to
use only parts specifically approved for
use with this heater may result in property dam-
age or personal injury.
This heater and components are heavy. Have
help available for assembly.
WARNING
Tools Required
• Phillips screwdriver (stub) • power drill
• utility knife • reciprocating saw
• metal drill bit: size 28 (.140”/3.5mm)
Unpack the Stove
The parts bag containing this manual also includes the
following parts:
• Remote Switch • Switch Bracket
• Switch Wire • 1/4-20 x 3/8” screws (3)
• Cement • Restrictor Plate
• #10 Sheet metal screws (2)
The logset and 4” inner vent starter pipe are packed in-
side the firebox. Use the following procedure to unpack
these parts.
1. Lift the stove front up and then swing the bottom out
and away to disengage it from the stove body. Refer
to Figure 37, Page 23.
2. Swing open the swiveling latches at the top left and
right corners of the glass frame. (Fig. 12)
NOTE: Verify the two relief doors (located on top of
the firebox) are properly seated on the gasket. The
doors should sit flush on the gasket and should lift
easily from the seal around the opening.
ST208
glass swivel latch
12/99
ST208
Fig. 12 Swivel the latches to release the glass frame from
the firebox.
3. Pull the top edge of the glass and frame assembly
away from the firebox and lift it off its supports on the
bottom of the firebox face. Place the assembly out of
the way on a flat, padded surface such as a counter
protected by a towel.
4. Take the logset and all other loose parts out of the
firebox and set them aside in a protected area for
installation after the venting is complete.
WARNING
This appliance is equipped with a three-prong
(grounded) plug for your protection against shock
hazard and should be plugged directly into a
properly grounded three-prong receptacle. Do not
cut or remove the grounding prong from this plug.
Install the Optional Fan
ST239
FDV attach snapstat
12/13/99 djt
1/4-20 x 3/8”
Phillips
Screw
1/2” Sheet
Metal Screw
Snapstat
Snapstat Bracket
ST239
Fig. 13 Snapstat assembly and installation.
If you are installing the optional convection Fan Kit
#2960 (FK28), continue here. If you will not install the
Fan Kit, go to Page 15, Venting System Assembly.
1. The fan kit includes a blower assembly and a
rheostat assembly connected by a cable. (Fig. 14)
The blower assembly and the rheostat mount to the
rear shroud of the stove. The assembly includes a
‘snapstat’ which automatically turns the fan ON (or
OFF) above (or below) approximately 109° F (43°
C). The rheostat also provides a range of fan speed
settings from Off (which overrides the snapstat
function) to HIGH. Unpack and inspect the blower
assembly. Confirm that the fan spins freely.
2. Attach the snapstat assembly to the snapstat brack-
et with two (2) sheet metal screws. (Fig. 13) Remove
the 1/4-20 x 3/8” hex head bolt installed in the hole
in the right rear ledge of the firebox. Use that bolt
to secure the snapstat bracket to the firebox. The
mounting hole is slotted to allow you to adjust the
bracket so the snapstat bracket head makes contact
with the firebox. (Fig. 13)