Filter
Top Products
5
10006943
Electrical Connection
A 15 Amp, 120 Volt, 60 Hz circuit with a properly
grounded outlet is required. Preferably, the appliance
will be on a dedicated circuit as other appliances on
the same circuit may cause the circuit breaker to trip
or the fuse to blow when the heater is in operation.
The unit comes standard with a 6’ (1.8m) long three
wire cord, exiting from the rear of the stove. Plan the
installation to avoid the use of an extension cord. If an
extension cord must be used, it must be a minimum
14AWG, three wire with grounding type plug connector
and rated not less than 1875 Watts. The cord shall not
be more than 20’ (6m) in length.
WARNING: Electrical outlet wiring must
comply with local building codes and
other applicable regulations to reduce the
risk of fire, electrical shock and injury to
persons.
WARNING: Do not use this stove if any
part of it has been under water.
Immediately call a qualified service tech-
nician to inspect the stove and replace
any part of the electrical system.
Clearance to Combustibles
Back . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2” (51 mm)
Sides . . . . . . . . . . . . . . . . . . . . . . . . . . . .6” (153 mm)
Floor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0” (0 mm)
Top . . . . . . . . . . . . . . . . . . . . . . . . . . . .24” (610 mm)
Hearth
A hearth is not mandatory, but is recommended for
aesthetic purposes. We recommend a noncombustible
hearth which does not obstruct heater openings.
Plexiglass Information
1. This product uses plexiglass on the door window.
2. Under no circumstances should this product be
operated with missing or broken plexiglass.
3. Do not strike or slam the plexiglass.
4. Do not use abrasive cleaners to clean the plexi-
glass.
Electric Specifications
Voltage . . . . . . . . . . . . . . . . . . . . . . . .120V AC/60Hz
Total Amps . . . . . . . . . . . . . . . . . . . . . . .12.20 Amps
Total Watts . . . . . . . . . . . . . . . . . . . . . . . .1460 Watts
Heater Ratings . . . . . . . . . . . . . . . . . . . .1300 Watts
Grounding Instructions
This heater is for use on 120 volts. The cord has a
plug as shown at A in Figure 1. An adapter as shown
at C is available for connecting three-blade grounding-
type plugs to two-slot receptacles. The green ground-
ing lug extending from the adapter must be connected
to a permanent ground such as a properly grounded
outlet box. The adapter should not be used if a three-
slot grounded receptacle is available.
A
B
C
Grounding Means
Cover of
Grounded
Outlet Box
Metal Screw
Grounding Pin
Adapter
Fig. 1 Grounding methods.