Filter
Top Products
10
CAUTION: The Motor Adapter has a special
coating on the threads. Do not remove this
coating; the coating prevents the downrod
from unscrewing. Once assembled, do not
remove the downrod.
HANGING THE FAN
Step 1. Trim wires to about 6" from the top of the
downrod.
Step 2. Strip 1/2" of insulation off each wire using
wire strippers. Raise the fan and place the ball into
the hanger bracket.
Step 3. Align the notch on the ball with the indent in
the hanger bracket. (Rotate the fan until you hear the
notch pop into place.)
Indention
Notch
WARNING: Fan may fall if
not assembled as directed
in these installation
instructions.
Step 5. Tighten the set screw as shown in Figure
#5 to ensure safe operation of your fan. If it is tight
enough, you should not be able to turn the downrod
counterclockwise with your hands. If in doubt, tighten
the set screw with until you cannot turn it any further.
FIGURE 5
Set Screw
Allen Wrench