Casablanca Fan Company 54042 Fan User Manual


 
www.CasablancaFanCo.com
1.888.227.2178
21
M6003-01 • 04/16/15 • © 2012–2015 Casablanca Fan Company
Troubleshooting
Fan doesn’t work
Press a fan speed button (1-4).
Check the wall control battery.
Check the circuit breaker to
ensure the power is turned on.
Make sure the blades spin freely.
Turn off power from the circuit
breaker, then loosen the canopy
and check all the connections
according to the wiring diagram
on page 10-11.
Check the plug connection in
the switch housing.
Excessive wobbling
Tighten all of the blade and
blade iron screws until they
are snug.
Turn the power off, support
the fan carefully, and check
that the hanger ball is
properly seated.
Use the provided balancing
kit and instructions to balance
the fan.
Noisy Operation
Tighten the blade and blade
iron screws until they are snug.
Check to see if any of the
blades are cracked. If so, replace
all of the blades.
Lights dim when turned on or
do not turn on at all.
Make sure the wattage of the
light bulbs installed matches
the specications on the
light sockets (see page 20 for
instructions on changing the
bulbs).
Remote does not work
Make sure the battery is installed
correctly.
Install a new battery.
If the remote still does not
work, you may need to pair
your remote. To prevent faulty
operation, please disconnect
power (at the wall switch,
breaker, or fan) from all other
ceiling fans within range while
pairing. To pair: cycle power
to the fan by turning power off
and back on at the wall switch
(or circuit breaker if necessary).
Within three minutes, press and
hold both the Fan Off button and
the 4 button for four seconds to
pair the remote. If applicable, the
fan will turn on and the lights
will ash and stay on to indicate
successful pairing.
AUTHORIZED SERVICE
CENTERS
For the most updated list of
Casablanca Authorized Service
Centers, visit
www.CasablancaFanCo.com or
call toll free 1-888-227-2178.
Lights will not dim
To enable dimming, you
must rst set your remote to
Dimming Mode. To toggle
Dimming Mode on or off, hold
down the Fan Power button
while pressing the Light Down
arrow twice.
Ensure each bulb you are using
supports dimming.