Filter
Top Products
7
Selecting the Fan Speed
SET TEMP.
C L O C K
SPEED
AUTO
AUTO LOW MED HIGH
A08036
The fan speed can be selected by pressing the FAN SPEED button.
NOTE: When the unit is on, the fan will run continuously in
cooling or heating. When in heating, there might be situations
where the fan will slow down or shut off to prevent cold blow.
Selecting the Horizontal Direction Louver Position
In order to optimize comfort, the horizontal louver will operate in
a preset range as shown in the figure below.
COOLING
HEATING
A08044
The horizontal louvers can be adjusted using the remote control
and can be set to be stationary or moving continuously.
Air Dir
ection
Press the AIR DIRECTION button repeatedly to choose one of the
louver positions.
Every time the air direction button is pushed, the louver will swing
by 6 degrees.
In the Cooling, Dehumidification, and Fan Only mode, the louver
will swing in the cooling range. In the Heating mode, the louver
will swing in t he heating range.
NOTE: Always use the remote control to adjust the louver
position, otherwise abnormal operation may occur. If the louver is
manually adjusted out of its range,turn the unit off and then on
again.
Auto Swing
To have the louver moving continuously, push the SWING button.
Push again to stop the louver.
Selecting Vertical Direction of the Louver
The vertical louvers can be adjusted manually to direct the airflow
to achieve the optimal comfort in the space.
A07543
Timer Function
TIMER ON (to start the unit) and TIMER OFF (to stop the unit)
can be used separately or together.
Timer ON only
SET TEMP.
C L O C K
SPEED
AUTO
AUTO
TIMER ON
A08037
This function will allow the unit to start automatically at the set
time. The TIMER ON can be set while the unit is on or off.
UNIT ON
-- Press the TIMER button once. The current time flashes next
to the TIMER ON display on screen. Press the temp
Y button
or temp
B button to set the desired “TIME ON”. Every time
the
Y or B button is pushed, the time increases or decreases
by 10 minutes.
-- When the TIMER ON is set, the TIMER light on unit
illuminates. The unit will shut of f and will start a gain at the
set time.
UNIT OFF
-- Set the timer described in the UNIT ON section.
-- Theunitwillstartatthesettime.
To cancel TIMER setting, press the CANCEL button.
Timer OFF only
SET TEMP.
C L O C K
SPEED
AUTO
AUTO
TIMER OFF
A08040
This function will allow the unit to stop automatically at the set
time. The timer can be set while the unit is on or while it is off.
UNIT ON
-- Press the TIMER button twice. The current time flashes next
to the TIMER OFF display on screen. Press the temp
Y
button or temp B button to set the desired “TIME OFF”.
Every time the Y or B button is pushed, the time increases
or decreases by 10 minutes.
-- When the TIMER OFF is set, the timer light on the unit
illuminates and the unit turns of f a utomatically at the set
time.
UNIT OFF
-- Set the TIMER off as described in the UNIT ON section.
-- The unit will turn on and will turn of f at the set time.
-- If TIMER OFF is canceled (by pushing the cancel button),
before the set time elapses, the unit will continue running.