Carrier 38VYX110 Heat Pump User Manual


 
GB - 4
38VYX110/38VYX130
Knockout procedure
The indoor/outdoor connecting pipes can be connected to 4
directions.
Take off the knockout part of the pipe cover in which pipes or
wires pass through the base plate.
As shown in the figure, do not remove the pipe cover from the
cabinet so that the knockout hole can be easily punched.
To knock out, punch the 3 connected parts with a screwdriver
and remove the pipe cover by hand.
After marking the knockout hole, remove the burr and mount
the attached protective bush and guard material for pass-through
part in order to protect pipes and wires.
After connecting the pipes, be sure to mount the pipe cover.
The pipe cover is easily mounted by cutting off the slit at the
lower part of the cover.
How to remove the front panel
1. Remove screws of the front panel.
2. Pull the front panel downward.
Removing the front panel, the electric parts appear at the front side.
The power supply cables can be inserted into the pipe holes.
Enlarge the pipe holes if they are too small.
The power supply cable and the indoor/outdoor connecting cable
must be fixed by means of the strip on the connection fixing
bracket so that they are not in contact with the compressor and
the hot pipes.
To ensure good tensile strength, the electric cables must be
fastened using the cable-holder on the plate.
Installation Place
A place which provides a specified space around the outdoor unit.
A place where the operation noise and discharged air are not
given to your neighbors.
A place that is not exposed to a strong wind.
A place that does not block a passage.
When the outdoor unit is installed in an elevated position, be sure
to secure its feet.
There must be sufficient space for carrying in the unit.
A place where the drain water does not make any problem.
If the unit is installed in areas where heavy snowfalls may occur, it
is necessary to raise its level at least 200 mm above the usual
snow level.
The support must be suitable for the unit weight.
CAUTION:
Install the outdoor unit at a place where discharge air is not blocked.
When an outdoor unit is installed in a place that is always exposed
to a strong wind like a coast or on a high storey of a building,
secure a normal fan operation by using a duct or a wind shield
When installing the outdoor unit in a place that is constantly
exposed to a strong wind such as the upper stairs or rooftop of a
building, apply the windproof measures referring to the following
examples.
Install the unit so that its discharge port faces the wall of the
building. Keep a distance 500 mm or more between the unit and
the wall surface.
Supposing the wind direction during the operation season of the
air conditioner, install the unit so that the discharge port is set at
right angle to the wind direction.
Installation in the following places may result in some troubles. Do
not install the unit in such places below.
A place full of machine oil.
A place full of sulphuric gas.
A place where high-frequency radio waves are likely to be
generated as from audio equipment, welders, and medical
equipment.
Selection of installation
Cover knockout for pipe connection
Rear direction
Pipe cover
Side direction
Down direction
Front direction
Electric parts box
Fixing plate
Piping hole
Cable-holder for
electric cables
Front panel
Strip
500
Strong wind