Filter
Top Products
- 20 -
WIRING INSTRUCTIONS
Wiring Color Code Power and Control Inputs
RJ45
BNC
(Large)
Power
(Small)
Alarms
AFTER CAMERA INSTALLATION
Make inside housing wiring connections following Chart B
below.
Chart A Wiring Color Code
Power and Control Inputs (Outside of housing)
POWER
1 Camera Power (+12 VDC) Red
2 Camera Power (-12 VDC) Orange
3 Accessory Power (+12 VDC) Yellow
4 Accessory Power (-12 VDC) Green
CONTROL RJ45 Ethernet Connector
ALARMS
1 Alarm 1 Blue
2 Alarm 2 Violet
3 Alarm 3 Gray
4 Common White
Chart B Power and Control Outputs (Inside of housing)
POWER
1 Camera Power (+12 VDC) Red
2 Camera Power (-12 VDC) Orange
ALARMS
1 Alarm 1 Blue
2 Alarm 2 Violet
3 Alarm 3 Gray
4 Common White
!
Be sure the bracket is properly and securely mounted
to a supporting structure capable of rigidly holding
the weight of the entire unit.
INSTALLING THE HOUSING ASSEMBLY:
NOTE: This unit is designed for operation in an
upright position. Installing the housing
upside down may cause damage to
the internal equipment, and will void the
warranty.
INSTALLING PENDANT MOUNT
1. This unit includes a 1½" NPT housing for a standard 1½"
NPT pipe. The housing can be used with other brackets
designed with 1½" male pipe threads, such as the WM20G
wall mount bracket.
2. Attach the housing coupling.
Add thread
sealing tape
NOTE: Pipe threads should be clean and rust-
free. Use the Teon
™
tape included with
the housing on the threads.
Teon Tape
A small roll of Teon tape is provided with all pendant units.