Cal Flame BBQ08953P Burner User Manual


 
Installation / Assembly
9
Cal Flame Side Burners
LTR50001082, Rev. B
www.calspas.com
Natural Gas
Requirements
The installation of this appliance must conform with local codes or,
in the absence of local codes, to the national fuel gas code, ANSI
Z223.1a-1998. Installation in Canada must be in accordance with the
standard CAN/CGA-B149.2, Propane Installation Code.
A licensed contractor or local gas company representative must per-
form all natural gas connections.
Ensure that the service supplying the side burner is tted with a shut
off valve conveniently positioned near the side burner and giving ease
of access.
The side burner must be isolated from the gas supply piping system by
closing its individual manual shutoff valve during any pressure testing
of the gas supply piping system at test pressures equal to or less than
0.5 psi (3.5 kPa).
The side burner and its individual shutoff valve must be disconnected
from the gas supply piping system during any pressure testing of that
system at test pressure in excess of 0.5 psi (3.5 kPa).
Connection
Slide the side burner forward to gain access to the gas connection 1.
point in the rear.
Connect a suitable ex connector to the gas connection point.2.
Check the side burner controls to ensure all control valves are in 3.
the full OFF position.
Turn on the main gas supply and check all connections for leaks 4.
using soapy water as described in the leak testing procedure sec-
tion.
Warning: If you see bubbles in the soapy solution at any of the connec-
tions, turn off the gas supply and tighten the connection. If tightening
the connection does not seal the leak, it may be necessary to replace
the ex hose.