Filter
Top Products
Figure 2
7. Slide the unit back into the fireplace. Check to be sure that the trim panels are properly po-
sitioned and lie flat against the front of the fireplace. If one of more of the panels is out of
position, slide the unit out and reset by loosening the mounting screws and repositioning in
the slot.
8. Reinstall the top trim panel by sliding the rear lip of the top trim panel underneath the front
lip of the mounting bracket already secured to top of unit.
NOTE: Mount the top trim panel so that it sits in front of the top of the side trim panels.
9. Obtain the brass trim kit provided with unit and slip over the top and sides of trim panels.
(Top ends of brass may need to be trimmed to fit.
10. If direct connect or positive connect kit is not used, follow instructions in steps 1-4c on pre-
vious page.
11. Mount top trim panel by drilling mounting holes in center of trim panel mounting brackets,
with top end side of top panel overlapping side panel.
12. Using insulation provided, peel and stick to back of panels overlapping fireplace dimensions
by 1" on each side and top. (See Figure 3.)
13. Next using high heat silicone or furnace cement run heavy bead of caulking around where
panels meet the stove. (See Figure 3.)
9