Filter
Top Products
4
IMPORTANT FACTS
Your furnace must have adequate
airflow for efficient combustion
and safe ventilation. Do not
enclose it in an airtight room or
“seal” it behind solid doors.
To minimize the possibility of
serious personal injury, fire, fur-
nace damage, or improper opera-
tion,
carefully follow these
safety rules:
3
• Do not cover the furnace, store
trash or debris near it, or in any way
block the flow of fresh air to the
unit.
• Combustion air must be clean and
not contaminated with chlorine or
fluorine. These compounds are
present in many products around
the home, such as: water softener
salts, laundry bleaches, detergents,
adhesives, paints, varnishes, paint
strippers, waxes, and plastics.
Make sure the combustion air for
your furnace does not contain any
of these compounds. During re-
modeling be sure the combustion
air is fresh and uncontaminated. If
air with vapors of these com-
pounds is burned in your furnace,
the heat exchangers and metal vent
system may deteriorate.
NOTE:
Do not use this furnace if
any part has been under water.
Immediately call a qualified ser-
vice technician to inspect the fur-
nace and to replace any part of the
control system, electrical compo-
nents, and any oil control which
has been under water.
NOTE:
The qualified installer or
agency must use only factory-
authorized replacement parts, kits,
and accessories when servicing
this product.
The furnace burner control has a
safety device which must be man-
ually reset. If the furnace is left
unattended for an extended period
of time, have it checked periodi-
cally for proper operation. This
precaution will prevent problems
associated with no heat, such as
frozen water pipes, etc.
SAFETY
CONSIDERATIONS
Installing and servicing of heating
equipment can be hazardous due to
oil and electrical components.
Only trained and qualified person-
nel should install, repair, or service
heating equipment.
Untrained personnel can perform
basic maintenance functions such as
cleaning and replacing air filters. All
other operations must be performed
by trained service personnel.
Observe safety precautions in this
manual, on tags, and on labels
attached to the furnace and other
safety precautions that may apply.
Recognize safety information.
This is the safety-alert symbol .
When you see this symbol on the
furnace and in instructions or man-
uals, be alert to the potential for
personal injury.
Understand the signal words —
DANGER, WARNING, and CAU-
TION. These words are used with
the safety-alert symbol. DANGER
identifies the most serious hazards
which
will
result in severe personal
injury or death. WARNING signi-
fies hazards which
could
result in
personal injury or death. CAU-
TION is used to identify unsafe
practices which
may
result in
minor personal injury or product
and property damage. NOTE is
used to highlight suggestions which
will result in enhanced installation,
reliability or operation.
STARTING YOUR
FURNACE
This appliance is equipped with an
ignition device which automatical-
ly lights the burner each time the
thermostat starts your furnace.
Fol-
low these important safe-
guards:
4
FOR YOUR SAFETY
Do not store or use gaso-
line or other flammable
vapors and liquids in the
vicinity of this or any oth-
er appliance.
!
WARNING
FIRE, EXPLOSION, CARBON
MONOXIDE POISONING
HAZARD
Failure to follow this warning
could lead to sooting, fire, ex-
plosion, and/or severe bodily
harm.
For use with grade 2 Fuel Oil
maximum. Do not use Gaso-
line, Crankcase Oil, or any Oil
containing Gasoline!
CAUTION
FIRE AND UNIT OVERHEAT
HAZARD
Failure to follow this caution
may result in unit damage.
Never burn garbage or paper
in the heating system and
never leave rags, paper, or
any flammable items around
the unit.
WARNING
EXPLOSION HAZARD
Failure to follow this warning
could result in property dam-
age or personal injury or
death.
This furnace is equipped with
a constant type primary igni-
tion system. DO NOT AT-
TEMPT TO LIGHT WITH A
MATCH.
!
!
!