Filter
Top Products
280ANV EVOLUTION
R
EXTREME
VARIABLE SPEED HEAT PUMP
WITH PURONr REFRIGERANT
(2 -- 5 Ton)
Owner’s Manual
A NOTE ABOUT SAFETY
Any time you see this symbol in manuals, instructions and on
the unit, be aware of the potential for personal injury. There are
three levels of precaution:
DANGER identifies the most serious hazards which will result in
severe personal injury or death.
WARNING signifies hazards that could result in personal injury or
death.
CAUTION is used to identify unsafe practices which would result
in minor personal injury or product and property damage.
NOTE is used to highlight suggestions which will result in
enhanced installation, reliability, or operation.
PERSONAL INJURY, DEATH AND / OR PROPERTY
DAMAGE HAZARD
Failure to follow this warning could result in personal injury,
death or property damage.
Improper installation, adjustment, alteration, service,
maintenance, or use can cause explosion, fire, electrical shock,
or other conditions which may cause personal injury or
property damage. Consult a qualified installer, service agency,
or your distributor or branch for information or assistance. The
qualified installer or service agency must use
factory--authorized kits or accessories when modifying this
product.
Read and follow all instructions and warnings, including labels
shipped with or attached to unit before operating your new heat
pump.
!
WARNING
ABOUT YOUR HEAT PUMP SYSTEM
Identifying Your System
Your new Bryant heat pump system is what we call a ”split
system.” It has an outdoor unit and an indoor unit connected to
each other with copper tubing called refrigerant lines. Each of
these units has a rating plate with the model and serial numbers
you will need to reference when calling an authorized Bryant
dealer about your system.
Take a few moments now to locate those numbers and record them
in the spaces provided on the cover of this booklet.
USING YOUR NEW BRYANT SYSTEM
Your Bryant heat pump system is controlled by a wall--mounted
Evolution Control installed inside your home. This system
requires an Evolution Control which has software designed
specifically to operate this system. See the Evolution Control
Homeowner Guide for more details on system operation.
EVOLUTION EXTREME VARIABLE SPEED
OPERATION
You may notice your system runs for longer periods of time. This
system is designed to meet cooling or heating needs of the home at
a wide range of conditions. Your indoor temperature will remain
more consistent with fewer drafts, better humidity control,
enhanced comfort and enhanced energy efficiency.
HEATING AND COOLING YOUR HOME
For heating or cooling operation, make sure the System or Mode
control is set to the appropriate mode. Then, adjust the
Temperature control to your desired setting. Finally, use the Fan
control to select Automatic (turns on and off as heating is needed)
or On (runs continuously).
Depending on your typical heating needs, your home comfort
system may also include a supplementary heating source that will
automatically turn on as needed. You may also select this heat
source manually if desired.
OPERATION UNDER EXTREME
CONDITIONS
Your heat pump will run as long as necessary to maintain the
indoor temperature selected on your Evolution Control. On
extremely hot days, your heat pump will run for longer periods at a
time than on moderate days. Your system will also run for longer
periods of time under the following conditions:
S Frequent opening of exterior doors
S Operating laundry appliances
S Taking hot showers
S More than the usual number of people present in the home
S More than the normal number of electric lights in use
S Drapes or blinds are open on the sunny side of the home
IMPORTANT HEAT PUMP FACTS
Heat pump systems have a few unique features and operations that
you should be aware of:
S During the heating cycle, your heat pump delivers a constant
flow of air at around 95° to about 105° F, compared to sudden
blasts of hot air provided by a typical furnace.
S Ice or frost may form on the outdoor coil during winter heating
operation. Your heat pump will automatically melt the ice us-
ing its defrost cycle. During defrost, you may see steam or fog
rising from the outdoor unit, which is normal. At the beginning
and end of the defrost cycle, you may hear a "whoosh" sound
coming from the unit. This is normal for heat pump
applications.
S Heat pumps installed in areas expecting snow are elevated with
support feet.