Bryan Boilers CLM-210 50 Boiler User Manual


 
Bryan Knockdown
TM
boilers for stage-by-stage
entry through most standard door openings
Replace old inefficient boilers without extra construction expense
Sizes from 29 BHP to 191 BHP
Bryan offers a large selection of
hot water and steam industrial and
commercial boilers that have been
designed for delivery to the site
partially assembled in an easy-to-
knockdown configuration.
Reassemble inside The indi-
vidual components will all easily
fit through standard door open-
ings. The boilers can then be
readily reassembled inside so you
can replace old boilers even in
closed-in restricted space.
No demolition and reconstruction expense All of this
can be done without tearing out walls, and without requir-
ing the services of an ASME welder.
Bryan high efficiency performance All feature Bryan’s
flexible water tube design which ensures fast, efficient
conversion of fuel to heat, easy removal and replacement
without welding. Dramatically reduced floor space is
required by the compact designs and an absolute mini-
mum area is needed to service water tubes.
A variety of knockdown stages Several states of partial
to complete assembly are available depending on boiler
size and on-site considerations. Consult your Bryan
Boilers Representative to select the configuration best
suited to your particular require-
ments. These are:
KD-1 Boiler is shipped com-
pletely assembled ready for
knockdown, single screws, tack
welds, not welded to base.
KD-2 Disassembled after in-
spection, shipped as vessel
with tubes installed, base with
burner (atmospheric) or refrac-
tory (forced draft), controls,
jacket and flue collector packed
in separate crates.
KD-3 Same as KD-2 except tubes removed from vessel.
KD-4 (RV only) Partially assembled ready for knock-
down. Single screws and tack welded, burner not in-
stalled, refractory not poured, assembly required. Weld-
ing required, but no ASME code work needed.
KD-5 (RV only) All components disassembled after in-
spection and shipped in crates. Refractory not poured,
assembly with welding required, but no ASME code work
needed.
KD-6 All custom knockdown configurations other than
above. Specify exact requirements and contact factory for
availability and pricing.