Browning TG23F Home Safety Product User Manual


 
20
21
CARPET
The key to removing stains from your carpeted interior is to clean
them as soon as they occur. Do not soak the carpeting with water to
remove stains. Small amounts of water can permanently damage the
fire-resistant materials within your safe if the water is allowed to soak
into the carpeted areas. Use any household carpet spot remover to
clean up stains. Follow the directions on the product itself.
DPX AND DPH SYSTEM INTERIOR MATERIALS
Several other materials are used in the construction of the patented
DPX Storage System and the DPH Storage System. No specific
maintenance is required for these systems, and they can be spot
cleaned using mild detergent and water on a clean cloth. Care should
be taken to avoid excessive pulling on sewn seams as items are added
to or removed from the pockets, pouches and loops of the DPX and
DPH systems.
The safe interior should always be loaded before storing any firearms
on the DPX door rack to prevent tipping or weight imbalance.
HANDLE
Some chemicals or abrasive cleaners can damage gold, brass or
chrome handle finishes. The spokes, handle and hub on your safe
should be cleaned only with a soft, damp cloth. No abrasives or
chemicals of any kind should be used.
LOCKING BOLTS
The tolerances between your locking bolts and the safe body and door
are very tight. Because they fit so tightly, it may be necessary from
time to time to place a small amount of Teflon
®
lubricant on the
bottom of each bolt with the bolts in the extended position.
MIRROR INTERIOR
If your safe is equipped with an interior mirror on the back panel,
use only rubbing alcohol or distilled water and a soft cloth to clean
the mirror.
BULB REPLACEMENT
1 Prior to replacing a bulb, turn the light switch off and
unplug the light. Allow the bulb to cool before replacing.
2 Twist lens cover counterclockwise.
3 Use only Type JCDGY8 20 watt 120 volt halogen bi-pin
replacement light bulbs.
Notice! do noT Touch The bulb aT any Time. use a dry sofT clean
cloTh To Touch bulb while replacing.
4 Make sure the replacement bulb is installed correctly. (If you have
questions contact customer service.)
6 Remove soft cloth from new replacement bulb before putting lens
cover back on.
7 Replace lens cover with a clockwise motion.
CARE
SAFE BODY
All Browning ProSteel safe paint finishes are designed for indoor
use only. Use a damp rag to wipe down the surface of the safe. If
something other than water is needed, a very mild soap solution may
be used. However, only water should be used around the detailing
areas. Care should be taken around the art scene, pinstripe, corners or
logo to avoid catching and peeling any edges with the cleaning cloth.
ART SCENE
If your safe was manufactured with our exclusive art scene transfer
process you must take particular care not to clean your safe with any
ammonia-based cleaners. Glass cleaners like Windex
®
can permanently
damage the art scene and other portions of the safe detailing package.
Do not attach anything to the body or detailing materials with tape.
Tape may remove the art scene, paint and other portions of the
detailing package.
07-137-BSF_Safe OM.indd 20-21 7/21/08 11:13:09 AM