Filter
Top Products
KNOWING YOUR SEWING MACHINE —————————————————————————————————————————————
—
18
Upper Threading
1 Spool pin
2 Thread guide
3 Tension discs
4 Thread take-up lever
Set the main power switch to “O”.
1
Raise the presser foot lever and turn the balance
wheel toward you (counterclockwise) to raise
the thread take-up lever to its highest position.
2
Pull up the spool pin and put a spool of thread
on this pin.
3
Pass the thread through guides.
1 Spool pin
2 Thread guide
3 Tension discs
4 Thread take-up lever
4
While holding the thread, pull it between the
tension discs.
5
Guide the thread to the back of the thread
take-up lever and around to the left. Bring the
thread through the slit by pulling it toward
you and into the eyelet.
1 Thread take-up lever
2
4
1
3
● Make sure you thread the machine
properly, otherwise the thread could
tangle and break the needle.
●
If the spool of thread is in the wrong place, or
is set incorrectly, the thread may tangle on
the spool pin and cause the needle to break.
CAUTION
CAUTION
2
4
3
1
1
1
XL5000us.book Page 18 Tuesday, November 11, 2003 9:25 AM