Filter
Top Products
Troubleshooting 187
5
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Error messages
When erroneous operations are performed messages and advice on operation will be displayed on the LCD.
Follow what is displayed. If you press or do the operation correctly while the error message is
displayed, the message disappears.
Error Message Probable Cause
There is a possibility that the data for the selected pattern is corrupted.
Either the start/stop button or the reverse/reinforcement stitch button
was pressed at a screen other than the sewing screen.
The start/stop button was pressed without connecting the foot controller
while the setting for adjusting the stitch width using the sewing speed
controller is set to “ON”. You have selected a pattern for which width
control cannot be used.
The twin needle setting is selected while a pattern that cannot be sewn
with the twin needle is selected.
Upper thread broken.
Upper thread not set up correctly.
Upper thread has run out.
CAUTION
Be sure to rethread the machine. If you press the start/stop button
without rethreading the machine, the thread tension may be wrong or
the needle may break and cause injury.
You tried to create a design with too many points with the My Custom
Stitch function.
The machine is deleting a previously saved pattern while in embroidery
edit mode.
The start/stop button was pressed while the foot controller was
connected. You tried to use the foot controller for embroidery.
While embroidering, data is written to the “Removable Disk” in the
connected computer or data is deleted from the “Removable Disk”.
The start/stop button was pressed before the editing was completed
with the My custom stitch function.
on the LCD was pressed when no card was inserted.