Filter
Top Products
USING ATTACHMENTS AND APPLICATIONS ————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————————
—
————————————————————————————————
—————
31
Darning
1
Turn off the machine.
Place the darning plate on the needle
plate, then turn on the machine.
2
Either remove both the presser foot and
presser foot holder assembly and then
lower the presser foot lever.
3
Put the section you want to darn under
the presser foot together with fabric for
reinforcement.
4
Turn on the machine.
CAUTION
5
Begin sewing by alternating between
gently drawing the work away from you
and pulling it toward you.
Note
● Sew while holding the fabric stretched in
order to keep the fabric held down.
6
Repeat this motion until the section being
darned is filled with parallel lines of
stitching.
Stitch Name Pattern
Stitch
Length
[mm (inch)]
Other
Straight Stitch
(Center Needle
Position)
1.6 (1/16)
Darning
Plate
Straight Stitch
(Center Needle
Position)
1.8 (1/8)
Darning
Plate
Straight Stitch
(Center Needle
Position)
2 (1/16)
Darning
Plate
Straight Stitch
(Center Needle
Position)
3 (1/8)
Darning
Plate
Straight Stitch
(Center Needle
Position)
4 (3/16)
Darning
Plate
Straight Stitch
(Left Needle
Position)
2.5 (3/32)
Darning
Plate
●
Do not turn on the machine while pressing
down the foot controller. The machine
may start unexpectedly and cause
personal injury or damage to the machine.
6
7
8
9
10
11