Filter
Top Products
2
Sewing 49
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Selecting stitching
Stitches are selected using LCD operations. There are
67 utility stitches. Right after turning the power on,
the straight stitch (left needle position) is selected.
a
Determine the stitch to be used, and get the
matching presser foot ready.
• Refer to "Stitch Setting Chart" (page 70).
b
Attach the presser foot.
The machine comes with zigzag foot "J"
attached.
• For details, refer to "Replacing the presser
foot" (page 43).
CAUTION
c
Turn on the sewing machine.
X The straight stitch (left needle position) is
shown selected on the screen.
d
Select a stitch.
(Previous page key) displays the previous
page, and (Next page key) displays the
next page.
Memo
z When touching the screen with your finger
is difficult, use the included touch pen.
Example:
11
is selected:
X The number of selected stitch, the stitch
width and the stitch length are displayed.
e
If necessary, specify the settings, for automatic
reverse/reinforcement stitching and adjust the
stitch length, etc.
• For details on sewing with each of the utility
stitches, refer to "Stitch Setting Chart" (page
70).
Note
z When a stitch is selected, the icon for the
presser foot that should be used appears on
the screen. Check that the correct presser
foot is attached before starting to sew. If the
wrong presser foot is installed, turn off the
sewing machine, attach the correct presser
foot, and then select the desired stitch again.
Memo
z For details on setting the automatic reverse/
reinforcement stitching etc., refer to "Useful
Functions" (page 61).
z For details on adjusting the stitch width,
stitch length and thread tension, refer to
"Setting the Stitch" (page 57).
z
Use the presser foot appropriate for the
stitch. If the wrong presser foot is used,
the needle may hit the presser foot and
bend or break.