Filter
Top Products
102
UTILITY STITCHES — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Free-motion quilting
With free-motion quilting, lower the feed dogs (using
the drop feed lever) so that the fabric can be moved
freely in any direction.
When free-motion quilting, use the following
instructions with the optional free-motion open toe
quilting foot "O" (SA187, F061 (XE1097-001)).
CAUTION
a
Remove the presser foot and the presser foot
holder.
• Refer to "Removing and attaching the presser
foot holder" (page 45).
b
Attach free-motion quilting foot "O" by
positioning the pin of the quilting foot above
the needle clamp screw and aligning the
lower-left of the quilting foot and the presser
bar.
a Pin
b Needle clamp screw
c Presser bar
Note
z Make sure that the quilting foot is not
slanted.
c
Hold the quilting foot "O" in place with your right
hand, and then tighten the presser foot holder
screw using the screwdriver in your left hand.
a Presser foot holder screw
CAUTION
d
Slide the drop feed lever, located at the rear of
the machine on the base, to (to the left as
seen from the rear of the machine).
a Drop feed lever (as seen from the rear of the
machine)
X The feed dogs are lowered.
e
Turn on the sewing machine, and then select a
stitch
3
or
24
.
• For details, refer to "Selecting stitching" (page 49).
f
Use both hands to stretch the fabric taut, and
then move the fabric at a consistent pace in
order to sew uniform stitches roughly 2.0-
2.5mm (approx. 1/16 - 3/32 inch) in length.
Reinforcement stitches are sewn at the
beginning and end of sewing.
a Stitch
g
After sewing is finished, slide the drop feed
lever to (to the right as seen from the rear
of the machine) and turn the handwheel to
raise the feed dogs.
Memo
z The drop feed lever is normally set to the
right side.
● Be sure to use the optional free-motion
open toe quilting foot "O" when making
free-motion quilting. If the quilting foot
(SA129, F005N (XC1948-002)) is used,
the needle threader may be damaged.
1
2
3
● Be sure to securely tighten the screw with
the screwdriver. otherwise the needle
may touch the presser foot, causing it to
bend or break.
a