Brother 885-V31/V33 Sewing Machine User Manual


 
108
UTILITY STITCHES — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Eyelet Stitching
Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm (1/4, 15/
64 and 3/16 inch).
CAUTION
a
Attach monogramming foot "N".
For details on replacing the presser foot, refer
to "Replacing the presser foot" (page 43).
b
Select stitch
62
.
For details, refer to "Selecting stitching"
(page 49).
c
Adjust either the stitch width or the stitch
length to select the desired eyelet size.
For details, refer to "Adjusting the stitch
width" (page 57) and "Adjusting the stitch
length" (page 59).
d
Lower the needle into the fabric at the
beginning of the stitching, and then lower the
presser foot lever.
e
Start sewing.
X Once sewing is completed, the sewing
machine automatically sews reinforcement
stitches, then stops.
f
Use the eyelet punch to cut a hole in the
center of the eyelet.
When using the eyelet punch, place thick paper
or some other protective sheet under the fabric
before punching the hole in the fabric.
Memo
z If thin thread is used, the stitching may be
too open. If this occurs, sew the eyelet twice
before removing the fabric, one on top of the
other.
Stitch Name Pattern Application
Stitch Width
[mm (inch)]
Stitch Length
[mm (inch)]
Presser
Foot
Auto Manual Auto Manual
Eyelet stitch
62
Sewing eyelets, for example, on
belts
7.0
(1/4)
7.0, 6.0 or
5.0
(1/4, 15/64
or 3/16)
7.0
(1/4)
7.0, 6.0 or
5.0
(1/4, 15/64
or 3/16)
N
Be sure to turn off the main power before replacing the pressor foot. Otherwise, injuries may
occur if (Start/stop button) is accidentally pressed and the machine starts sewing.