Filter
Top Products
Page 5
MODEL QTRE080R
5.
Attach the duct connector bracket to the mounting
frame using the (1) screw provided. Position the bottom
edge of the duct connector bracket so it touches the
finished surface of the ceiling and tighten the screw.
CONNECT ELECTRICAL WIRING
INSTALL HOUSING
8. Install thumbscrew through flange of motor plate as
shown.
9. Squeeze grille springs and insert them into slots on
each side of housing. Push grille against ceiling.
6. Retrieve the existing electrical wiring from above the
ceiling and use a UL approved connector to secure
it to the wiring plate. Re-attach wiring plate to fan
housing, if necessary. Connect wires as shown in
wiring diagrams.
7. Position the two movable brackets of the mounting
frame directly across from each other and insert the
housing into the mounting frame until it touches the
duct connector bracket. Secure the housing to the
mounting frame and duct connector bracket using
the (5) screws provided.
HOUSING
SCREW (5)
(provided)
MOUNTING
FRAME
DUCT CONNECTOR
BRACKET
EXISTING
ELECTRICAL
WIRING
WIRING
PLATE
(shown
removed
from fan
housing)
SCREW
(provided)
INSTALL THUMBSCREW
& GRILLE
THUMBSCREW