Filter
Top Products
HOW TO INSTALL THIS SMOKE ALARM
THE PARTS OF THIS SMOKE ALARM
FOLLOW THESE SIMPLE STEPS!
1. “OPEN HERE” tab
2. Cover hinge
3. Test button,
power/alarm indicator
6. Tighten the screws (provided) into the screw anchors, then loosen
them two turns.
7. Fit the smoke alarm over the screw heads as shown. Close cover.
8. If the smoke alarm cover does not line up the way you want it, rotate
the base and re-tighten the screws.
9. Activate the battery. With the cover open, remove and reinstall the
battery so the terminals on the battery match the terminals on the
smoke alarm. Match “+” to “+” and “-” to “-.” Push the battery in
until it snaps in securely and cannot be shaken loose.
If the battery is not snapped in completely, the unit cannot receive
battery power. The smoke alarm may beep briefly when you install
the battery—this is normal.
Once the battery is installed, the red power indicator light (behind
the test button) will flash once a minute to show you the smoke
alarm is working.
10. Close the cover all the way.
11. Test the smoke alarm. See “Weekly Testing.”
This unit is designed to be mounted on the ceiling, or on the wall if necessary.
Tools you will need:
• Pencil
• Drill with 3/16” (5 mm) drill bit
• Standard/flathead screwdriver
• Hammer
1. Hold base firmly and pull up on cover tab marked “OPEN HERE.” This
will open the hinged cover. The cover may unsnap from the base if it's
opened too far. This will not damage the unit—the cover hinge snaps
back into place easily.
2. Hold the smoke alarm base against the ceiling (or wall) and make a mark
at the center of each of the mounting slots with a pencil.
3. Put the unit where it won’t get covered with dust when you drill the
mounting holes.
4. Using a 3/16” (5 mm) drill bit, drill a hole through each pencil mark.
5. Insert the plastic screw anchors (in the plastic bag with screws) into the
holes. Tap the screw anchors gently with a hammer, if necessary, until
they are flush with the ceiling or wall.
1. “OPEN HERE” tab
2. Cover hinge
3. Test button,
power/alarm indicator
1. “OPEN HERE” tab
2. Test button,
power/alarm indicator
3. Sensor chamber
4. Smoke Alarm base
5. Mounting slots
6. Install 9V battery here
Model 83R
Model SA67B
Cover Open
Cover Open
1. “Open Here”▲
2. Test button
3. Smoke alarm base
4. “No Battery” tab
5A. Mounting slots
5B. Mounting slots
6. Install 9V battery here
2