Briggs & Stratton 246400 Plumbing Product User Manual


 
GB
1
Note: (This note applies only to engines used in the U.S.A.) Maintenance, replacement or repair of the emission control devices and systems may be performed
by any nonroad engine repair establishment or individual. However, to obtain no charge repairs under the terms and provisions of the Briggs & Stratton
warranty statement, any service or emission control part repair or replacement must be performed by a factory authorized dealer.
ENGINE COMPONENTS
Fig. 1
1
Fuel shut-off valve
2
Rope handle
3
Air cleaner
4
Engine Model Type Code
xxxxxx xxxx xx xxxxxxxx
5
Throttle and choke controls
6
Fuel fill
7
Stop switch
8
Blower housing
9
Oil drain plug
10
Muffler guard/Muffler
11
Carburetor
12
Spark plug wire
13
Oil fill/Dipstick − Low
14
12V electric starter, if equipped
15
Oil fill/Dipstick − High
Record your engine
Model, Type and Code numbers
here for future use.
Record your date of purchase here for future use.
TECHNICAL INFORMATION
Engine Power Rating Information
The gross power rating for individual gas engine
models is labeled in accordance with SAE (Society of
Automotive Engineers) code J1940 (Small Engine
Power & Torque Rating Procedure), and rating perfor-
mance has been obtained and corrected in accordance
with SAE J1995 (Revision 2002-05). Torque values are
derived at 3060 RPM; horsepower values are derived
at 3600 RPM. Actual gross engine power will be lower
and is affected by, among other things, ambient
operating conditions and engine-to-engine variability.
Given both the wide array of products on which engines
are placed and the variety of environmental issues
applicable to operating the equipment, the gas engine
will not develop the rated gross power when used in a
given piece of power equipment (actual on-site" or net
power). This difference is due to a variety of factors
including, but not limited to, accessories (air cleaner,
exhaust, charging, cooling, carburetor, fuel pump,
etc.), application limitations, ambient operating condi-
tions (temperature, humidity, altitude), and engine-to-
engine variability. Due to manufacturing and capacity
limitations, Briggs & Stratton may substitute an engine
of higher rated power for this Series engine.
GENERAL INFORMATION
In the state of California, Model 50000, 85400, 86400,
117400, 118400, 138400 engines are certified by the
California Air Resources Board to meet emissions
standards for 125 hours; Model 185400, 187400,
235400, 237400, 245400, 246400, 247400 for 250
hours. Such certification does not grant the purchaser,
owner or operator of this engine any additional
warranties with respect to the performance or opera-
tional life of this engine. This engine is warranted solely
according to the product and emissions warranties
stated elsewhere in this manual.
SAFETY SPECIFICATIONS
* Briggs & Stratton does not necessarily know what
equipment this engine will power. For that reason,
you should carefully read and understand the
operating instructions for the equipment on which
your engine is placed.
BEFORE OPERATING ENGINE
Read entire Operator’s Manual AND the
instructions for the equipment this engine
powers.*
Failure to follow instructions could result in
serious injury or death.
THE OPERATOR’S MANUAL CONTAIN SAFETY
INFORMATION TO
Make you aware of hazards associated with
engines
Inform you of the risk of injury associated with
those hazards, and
Tell you how to avoid or reduce the risk of injury.
The safety alert symbol is used to identify safety
information about hazards that can result in personal
injury.
A signal word (DANGER, WARNING, or CAUTION) is
used with the alert symbol to indicate the likelihood and
the potential severity of injury. In addition, a hazard
symbol may be used to represent the type of hazard.
DANGER indicates a hazard which, if not
avoided, will result in death or serious
injury.
WARNING indicates a hazard which, if not
avoided, could result in death or serious
injury.
CAUTION indicates a hazard which, if not
avoided, might result in minor or moderate
injury.
CAUTION, when used without the alert
symbol, indicates a situation that could result
in damage to the engine.
The engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth defects, or other reproductive harm.
WARNING
Briggs & Stratton does not approve or authorize
the use of these engines on 3-wheel All Terrain
Vehicles (ATVs), motor bikes, fun/recreational
go-karts, aircraft products or vehicles intended for
use in competitive events. Use of these engines in
such applications could result in property damage,
serious injury (including paralysis), or even death.
WARNING
Hazard Symbols
Explosion
Toxic Fumes
Moving Parts
Shock
Hot Surface
Kickback
Fire
International Symbols and Meanings
On Off
Fuel Shutoff
Read Owner’s
Manual
Stop
Fuel
ChokeSafety Alert
Oil
Gaseous fuels are extremely flammable and
readily form explosive air-vapor mixtures at
ambient temperatures.
WARNING
GB