Filter
Top Products
11
OPERATING YOUR BREVILLE PRODUCT
OPERATING
your Breville product
BEFORE FIRST USE
Remove any promotional material attached
to your kettle. It is recommended that before
first use, the kettle is filled to the maximum
level with cold tap water, boiled and water
discarded. Your kettle will only operate
when positioned on the power base with
the ‘On/Off’ switch in the ‘On’ position.
The kettle will automatically switch off
once the water has boiled.
OPERATION OF YOUR KETTLE
To fill the kettle, remove it from the power
base and open lid by pressing the lid release
button. Fill with the desired amount of water.
NOTE
Always fill the kettle between the
minimum (500ml) and maximum
(1700ml) marks on the water
window. Too little water will result
in the kettle switching ‘Off’ before
the water has boiled or reached the
selected temperature. Filling above the
maximum mark (MAX) may result in
boiling water splashing from the kettle.
Ensure the lid is locked firmly into place.
Position the kettle securely onto the power
base. Insert the power plug into a 230/240V
power outlet and switch on.
Press the ‘On/Off’ switch to the ‘On’
position for water to boil.
NOTE
This kettle must only be used with
the power base supplied. Use caution
when pouring water from your kettle,
as boiling water will scald. Do not
pour the water too quickly.
The kettle will automatically switch ‘off’
once the water has boiled. Lift the kettle
from the power base and pour the water.
Take care to hold the kettle level, especially
when filled to the maximum level. To re-boil
it may be necessary to wait for a few seconds
to allow the control to reset.
If further heating of the kettle is not
required, switch ‘Off’ at the power outlet,
unplug the power cord and empty the water
from the kettle. Replace the kettle onto the
power base and close the lid.
SAFETY BOIL DRY PROTECTION
The kettle is fitted with a safety device, which
protects against overheating should the
appliance be operated with insufficient water.
If this occurs, the kettle will stop heating.
Switch ‘Off’ at the power outlet and allow
kettle to cool before refilling. Remove the
kettle from the power base and add water.
Return the kettle to the power base. The
safety device will then automatically reset.
For additional safety, your kettle is fitted
with an additional thermal cut out. In
the event of overheating, the kettle will
automatically shut down to prevent further
damage. Should this occur, take your kettle
to an authorized Breville Service Centre.
WARNING
The appliance is designed for boiling
of drinking quality water only. Never
use to heat or boil any other liquids
or foodstuffs. The lid should always
be firmly in place and locked into the
closed position before use.
WARNING
Do not press the lid release button on
the handle to open the lid during and
after operation. This may result in
boiling water splashing from the kettle.
Pour out all the hot water from the
kettle before opening the lid to refill.