Breckwell P22FSL Gas Heater User Manual


 
SPECIFICATIONS
FREESTANDING:
Width: 21 ½”
Height: 28 ½” (with legs or pedestal)
Depth: 24”
Weight: 185 lbs.
Pedestal: 40 lbs.
Legs: 13 lbs.
Flue size: 3” or 4”
Hopper Capacity: Up to 45 lbs.
(this can vary widely depending on pellet size, length, and diameter)
EPA status: exempt
Burn time: 1 lb. to 4 ½ lbs. per hour
BTU range: 8,200 to 40,000
Approved installations: mobile home, alcove, conventional
FIREPLACE INSERT:
Width: 21 ½” (With flashing: 39”)
Height: 20” (With flashing: 30”)
Depth: 24” (In fireplace: 10 ¾”)
Weight: 185 lbs.
Flashing: 13 lbs.
Flue size: 3” or 4”
Hopper Capacity: Up to 45 lbs.
(this can vary widely depending on pellet size, length, and diameter)
EPA status: exempt
Burn time: 1 lb. to 4 ½ lbs. per hour
BTU range: 8,200 to 40,000
Approved installations: zero-clearance, masonry, as a built-in
PREPARATION
Factory packaging must be removed, and some minor assembly work is required
prior to installation. Access to the rear of the stove is necessary.
The circuit board/control panel must be unpacked and installed in the side
flashing on the insert or side panel on the freestanding.
(See installation instructions provided with the circuit board)
NOTE: Normally, your dealer will perform these functions.
CLEARANCES
The Breckwell P22 Freestanding has been tested and listed for installation in
residential, mobile home and alcove applications.
The P22 Insert is approved for installation into code complying masonry
fireplaces. It is also approved for use in listed factory built fireplaces (UL 127)
and standard residential built-ins (see As A Built-In Fireplace), including Mobile
Home built-in installations, of the following description: all brands at least 34”
wide and 20 ½” high.
FLOOR PROTECTION: Freestanding installations, minimum 21” wide by 28”
deep. The stove must be placed on a continuous (grouted joints) noncombustible
material such as ceramic tile, cement board, brick, 3/8” millboard or equivalent,
or other approved or listed material suited for floor protection.
THE MATERIAL(S) USED MUST HAVE, OR COMBINE TO HAVE, A MINIMUM
INSULATIVE RATING OF ‘R1’.
NOTE: ceramic tile, or any tile, requires a continuous sheet beneath to prevent
the possibility of embers falling through to the combustible floor if cracks or
separation should occur in the finished surface, this would include floor
protection for Built-in raised hearths. Check local codes for approved
alternatives.
Clearances are measured from the sides, back and face (door opening) or stove
body (refer to fig. 4).
DO NOT USE MAKESHIFT MATERIALS OR COMPROMISES IN THE
INSTALLATION OF THIS UNIT.
INSTALL VENT WITH CLEARANCES SPECIFIED BY THE VENT
MANUFACTURER.
IN
S
TALLATI
O
N
5
FIGURE 1
ALCOVE CLEARANCES
FIGURE 2
FIGURE 3
FLOOR PROTECTION
FIGURE 4