Filter
Top Products
D. AS A BUILT-IN FIREPLACE
Figures 18 and 19 describe a P22
installation vented into either a
special chase built outside an outer
wall or a false inside wall. This is
especially suited for new
construction or remodeling.
The equipment compartment (sides
and rear of the stove in fireplace)
must be enclosed per the
applicable electrical standards.
This can be accomplished by the
use of Breckwell’s panel kit part
#A-PANEL-22.
NOTE: Floor protection for Built-in
raised hearths requires a
continuous sheet beneath to
prevent the possibility of embers
falling through to the combustible
floor if cracks or separation should
occur in the finished surface.
The chase dimensions shown
are minimums and must be
maintained.
FIGURE 18
IN
S
TALLATI
O
N12
FIGURE 19