Bradford-White Corp IGE-199C Series Water Heater User Manual


 
SECTION IV: INSTALLATION INSTRUCTIONS
8
WARNING
INSTALLATION OF THIS WATER HEATER REQUIRES ABILITY EQUIVALENT TO
THAT OF A LICENSED PLUMBER. PLUMBING, AIR SUPPLY, VENTING, GAS
SUPPLY AND ELECTRICAL WORK ARE REQUIRED.
DO NOT ATTEMPT TO LIGHT ANY GAS APPLIANCE IF YOU ARE NOT CERTAIN OF
THE FOLLOWING:
Liquefied petroleum gases/propane gas and natural gas have an odorant added b
y
the gas supplier that aids in detection of the gas.
Most people recognize this odor as a “sulfur” or “rotten egg” smell.
Other conditions, such as “odorant fade” can cause the odorant to diminish in
intensity, or “fade”, and not be as readily detectable.
If you have a diminished sense of smell, or are in any way unsure of the presence
of gas, immediately contact your gas supplier from a telephone in another building.
Gas detectors are available. Contact your gas supplier or plumbing professional fo
r
more information.
Liquefied petroleum gases/propane gas is heavier than air and will remain at floor level i
f
there is a leak. Basements, crawl spaces, closets and areas below ground level will serve
as pockets for accumulation of leaking gas. Before lighting, smell all around the appliance
area for gas. Be sure to smell next to the floor.
IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electric switch; do not use any telephone in your building.
Immediately call your gas supplier from a telephone in another building. Follow the
gas supplier’s instructions.
If you cannot reach your gas supplier, call the fire department.
DO NOT OPERATE THE APPLIANCE UNTIL THE LEAKAGE IS CORRECTED!
WARNING
This water heater must be located in an area where leakage of the heat exchanger coil,
water line connections, or the pressure relief valve will not result in damage to the area
adjacent to the water heater or the outside building structure.