Bosch Appliances PSJ120S-102 Electric Heater User Manual


 
-7-
0,+>>/<C</6/+=/>+,=+</
-
<+-5/. 9< 9>2/<A3=/
.+7+1/. .9 89> 38=/<> 38>9 ,+>>/<C
296=>/<-98><966/< Battery can fall out during
operation.
"!!&!&! !&%
#")$
Locate the Heating Elements Power Cable
inside the battery holster/controller pocket,
and plug it into the battery holster/controller’s
heating elements power port. With a charged
battery, the Power Button and Heat Level
Controller will temporarily light up, indicating
the system is powered and ready to be turned
on.
989>+669A>2/-9<.=>9
,/-97/:38-2/. Pinched
wires increase the risk of shock and burns.
Store the battery holster/controller into its
designated pocket during usage of the jacket.
&"#$&"!
To turn the jacket’s heating elements on, first
make sure a charged battery pack is installed.
To turn the jacket on, hold the Power Button
until the LED lights up “RED.” Note that when
initially turned on, the jacket will be in the
“High Heat” level.
9 89> >9?-2 2/+>381
/6/7/8>=A3>2,+</=538
Burns can result from improper use.
To turn the jacket off, hold the Power Button
until the LED light goes off.
If the heated jacket turns off unexpectedly,
c
heck connections and charge the battery
pack.
9 89> ?=/ >2/ 2/+>/.
4+-5/>30>2/:9A/<,?>>98
.9/=89>>?<83>98+8.900 Any heated
jacket that cannot be controlled with the power
button is dangerous and must be repaired.
'%&!&&(
To adjust the heat level, press the Power
Button and Heat Level Controller once for
each level. The following LED light colors
represent the three heat levels.
$ – high heat
$! – medium heat
' – low heat
&/7:/<+>?</=?003-3/8>6C
2312>9-+?=/,?<8=7+C
9--?<</1+<.6/==90-98><96=/>>381 If any
discomfort occurs, shut off jacket power
immediately.
'%#"$&&&$*'#
"#$&"!
The USB port battery backup functionality
provides users with the ability to obtain extra
power from their Bosch 12V max battery, in
the event a cell phone, mp3 player or other
battery powered device runs low on power.
989>-988/->+8C./@3-/
>2+>3=89>-97:+>3,6/A3>2
(:9A/<=9?<-/>9>2/'%:9<>98
>2/,+>>/<C296=>/<-98><966/<Charging of
non-compatible devices may create a risk of
Battery holster/controller malfunction.
The battery holster/controller can be placed
within the battery holster/controller pocket or
can be attached to the user’s belt with the
convenient belt clip.
To use the USB cord supplied with your
personal device, plug the USB cable into the
USB port and the other end into your device.
To activate or wake-up the USB power port,
press the USB port wake-up button for 3
seconds (see page 6).
When pressed, the USB port will determine if
a device is plugged in. If so, the USB port will
remain on as long as the device is attached
for a maximum of 2 hours. If after 60 seconds,
the port does not detect a device initially
connected, it will deactivate, or go to sleep,
conserving battery power.
!
WARNING
!
WARNING
!
WARNING
!
WARNING
U
S
B
O
N


!
WARNING
!
WARNING
BM 2610031756 08-13_BM 2610031756 08-13 8/15/13 9:40 AM Page 7