Filter
Top Products
Video Manager | Instruction Manual | Operation
Bosch Security Systems | December 5, 2005
EN
|
16
Functional Notes for Figures 7 & 8:
1. Using keyboard 1, full control of the selected video
device is available on the monitors connected to
Video Manager outputs 1A and 1B.
2. Using keyboard 2, full control of the selected video
device is available on the monitors connected to
Video Manager outputs 2A and 2B.
3. Using keyboard 3, full control of the Monitor A or
Monitor B outputs of the selected video device is
available on the monitor connected to Video
Manager output 3A.
4. Using keyboard 4, full control of the Monitor A or
Monitor B outputs of the selected video device is
available on the monitor connected to Video
Manager output 4A.
NOTE: No special alarm monitor switching is
supported when four keyboards are connected in
the system.
7. 0 O P E R AT I O N
Video Manager operation is automatic. The unit
completely configures itself during the power-on
process, based on the quantity of keyboards and the
types of video devices being used.
Refer to the instructions supplied with the video
devices and/or the keyboards for complete information
on the operation of the video devices and any
pan/tilt/zoom equipped cameras connected to them.
8.0 MAINTENANCE
The Video Manager does not require any special
maintenance.
9.0 REPLACEMENT PARTS
Item: Part number:
Replacement Rack Mount Kit 303 1895 501
Replacement Keyboard Data Cable
303 0239 001
Replacement 390 Ohm Termination Device
303 2728 001
Replacement AC Line Cord, 120 VAC
Source from local
supplier
Replacement AC Line Cord 220-240 VAC
Source from local
supplier