Filter
Top Products
Bosch Security Systems | 2003-09 | 9922 141 50502en
Plena Message Manager | Installation and Operating Manual | en | 17
4Operation
4.1 Uploading
Figure 4.1
To upload the messages and to configure the sequence of the messages, a PC must be used that meets the following
minimum requirements:
- Pentium processor with a clock frequency of 100 MHz or higher
- Operating system: Windows 95® or higher
- CD-ROM drive
To prepare and to record the messages the standard available Windows® operating system can be used, but it is
also possible to purchase the messages from a studio. All messages must be stored as .wav files in the PC. Only
mono .wav files with sample frequencies of 24, 22.050, 16, 12, 11.025 and 8 kHz and a word length of 16 bits can be
used. The sample frequency for each separate message can be different. See §1.2.
To create messages or message sequences use the software on the CD-ROM supplied with the unit. To install this
software proceed as follows:
• Close all applications that are open.
• Insert the CD-ROM into the CD-ROM drive.
• In case the Setup-program does not start up automatically, go to the next step. Otherwise follow the instructions
on the screen.
•Choose Run from the Start-menu.
• Type 'd:\setup' (where 'd' is the CD-ROM drive).
• Click OK or press Enter.
• Follow the instructions on the screen.
Upon installation proceed as follows:
• Start the program. A screen similar to the following screen will appear.
Figure 4.2
Operation
1 2 3 4 6 75
89
Plena Message Manager