Filter
Top Products
6 720 608 542
Operation instructions
31
5.5 Use of optional remote control
accessory (part no. TSTAT2)
Fig. 47 Remote control
The wireless remote control accessory (Fig. 71,
component 13) and the temperature selector buttons
on the front of the water heater operate identically.
Contact your distributor to order the remote control
accessory. Modification of the water heaters interior
control unit (Fig. 71, component 16) is required when
programming the remote control with this heater.
5.6 Operation
B When a hot water tap is opened, main burner ignites
and LCD displays the symbol .
Fig. 48
B LCD blinks until selected temperature is reached.
5.7 Reset button
If the LCD shows the error symbol do not shut off
power or unplug the heater.
See the error code on LCD and consult
“Troubleshooting” section.
Fig. 49
After following instructions indicated in
“Troubleshooting” section.
B press reset button to return heater to normal
operation.
Fig. 50 Reset button
If the problem persists, contact your installer.
5.8 Program button
Program button can be used on the appliance and in the
remote control.
Programming “Program” function
Programming actions are similar for both controls
(appliance control pad and wireless remote control).
Fig. 51 “Program” key
Memorizing selected temperature
B Press buttons or to select temperature to be
memorized.
B Hold “Program” button for 3 seconds to save
temperature.
When LCD stops blinking, temperature is saved in
memory.
Using “Program” function
In order to select memorized temperature
B Press “Program” key.
LCD shows pre-memorized temperature, which is now
the hot water selected temperature.
5.9 Locked condition
This condition is only valid for appliances with remote
controls.
Fig. 52 Locked condition
Whenever LCD shows the temperature setting
cannot be adjusted because the appliance is in use by
a user which already selected a different temperature.
Appliance will be automatically unlocked five minutes
after closing the hot water tap.
i
NOTE: up to 6 remote controls can be
programmed for one single water heater,
each with a range distance of 98 ft (30 m).