Filter
Top Products
GV2 Series Control Panels | Owner's Manual Supplement
20 Bosch Security Systems, Inc. | 2/07 | F01U063791-01
For systems with access control, the following prompts are
available: ADD CARD?, CHANGE CARD?, and SUB USER
ID?. Refer to Systems With Access Control on page 20 for
details.
The system does not accept a passcode that is within two
digits of an existing passcode. This is to avoid conflicts with
duress passcodes. For example, if passcode 123 is already
programmed in the system, the system does not accept
121, 122, 124, or 125 as passcodes.
9. ADD LEVEL? appears. If the user number already exists,
CHANGE LEVEL? appears. Press [ENT].
10. VALID AREA 1? appears. If you wish this user number to be valid
in Area 1, press [ENT]. If not, press [NEXT].
11. AUTH LEVEL appears. Assign the authority level you wish the user
number to have for this area and press [ENT]. Record this
information.
12. VALID AREA 2? appears. Enter the information necessary for
the areas in the scope of the keypad by following steps 10 and
11 for each area (up to 8 areas).
13. LEVEL ADDED or LEVEL CHANGED appears when all area
assignments are made. Press [ENT].
At the end of each function, press [ESC] to return to the
ENTER USER # prompt. Press [ESC] again to return to idle
text.
Systems With Access Control
If your system includes access control features, such as card
readers at doors, the following prompts can appear during the
ADD USER? procedure.
ADD CARD? (CHANGE CARD?)
1. If the user has card or token access to the building or area,
press [ENT] at the ADD CARD? prompt, or at the CHANGE
CARD? prompt if the user already has a card or token.
2. PRESENT CARD appears. Present the card at the card reader
and wait for the tone.
3. If the reader identifies the card or token correctly, a tone
sounds and the keypad shows CARD ADDED, or CARD CHANGED
if the user already has a card or token. Press [ENT].