Filter
Top Products
D9412GV4/D7412GV4/D7212GV4 | Owner's Manual Supplement
12 Bosch Security Systems, Inc. | 9/11 | F01U245224-02
I have One of the following Passcode Functions configured:
Arm / Disarm (default) - All areas within the scope of the
user and keypad have their arm state changed. If the
current area is armed, it will disarm. If the current area is
disarmed, it will arm.
Cycle Door / Grant Access - The door associated with
the keypad will momentarily unlock. If enabled, the
current area will disarm or switch to perimeter armed,
then (if enabled) a custom function will execute (refer to
section 2.7 for details).
Cycle Relay - A pre-configured function will momentarily
activate.
Auto Re-Arm - All armed areas within the scope of the
user and keypad will restart their exit delay. If the current
area is disarmed, no action is taken.
2.8.1 Dual Authentication
The GV4 Series control panels provide a dual authentication feature
using a keypad and a door reader.
When a keypad and door
controller reader are paired together, they require two forms of
identification from the same user before a pre-configured
passcode function is performed. The authenticating user must
have a passcode and a door credential assigned for the Dual
Authentication process to allow the configured operation to be
performed.
I have this feature.
I do not have this feature.
2.8.2 Dual Authentication Process
The Dual Authentication process can be performed by entering a
passcode followed by the [ENT] or [ENTER] key, then presenting
valid access credentials to the associated Door Controller reader.
The Dual Authentication feature is only available on the
D9412GV4 and D7412GV4