Filter
Top Products
D9000,G & GV2 Series | Owner's Manual Supplement
Bosch Security Systems | 5/05 | 33267F 17
12.0 Add/Change
User - [COMMAND 56]
12.1 Description
Use this function to add or change a passcode or card without assistance
from your security company. Before adding or changing a passcode or
card, you must know which user numbers are available, the authority level
you want to assign to the new user, and the areas in which the passcode or
card are valid.
I have this feature.
I do not have this feature.
12.2 Using Add User ?
1. Ensure the display shows idle disarmed text.
2. Press the [COMMAND] bar. The display shows SYSTEM
COMMAND.
3. Press [5] and [6].
You can also use the Function List in place of steps 2 and 3 to
start this function.
1. Press the [MENU] key to enter the Function List.
2. Press [NEXT] until you reach the ADD/CHNG USER?
prompt.
3. Press [ENT].
4. The display shows ENTER USER #. Enter the user number and
press [ENT].
5. The display shows USER # (or user text, such as the name of the
user, if this feature was programmed into your system by your
security company) to allow for confirmation. Press [ENT] if the
correct user number (or user name) appears. Press [ESC] if not.
6. ADD PASSCODE? appears (If the user number already exists,
CHANGE PASSCODE? appears). Press [ENT]. ENTER NEW CODE