Filter
Top Products
-8-
REMOVING THE MOTOR
PROTECTION FILTERS
1.To open the filter access compartment,
use a coin to rotate the lock by 1/4 turn in
the direction of the arrow and push the
lock in.
2. Lift up the top section.
3. Grasp the filter, pull up and remove.
REPLACING THE MOTOR
PROTECTION FILTERS
See Figure 4.
1.Insert clean motor protection filters and
ensure firm seating.
2. Lower the top section.
3.With slight pressure from the top of the
control unit, the filter compartment lock
will snap back again.
WAND STORAGE
The wands from the optional VAC011 wand
kit can be stored in the recesses at the
bottom of the rear of the container. See
Figure 1.
BM 2610919254 12/02 12/18/02 10:52 AM Page 8