Black & Decker VC2000 Vacuum Cleaner User Manual


 
2
1
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, basic safety precautions should always be
followed, including the following:
Read all instructions before using this appliance.
WARNING – To reduce the risk of fire, electric shock or injury:
Do not leave appliance plugged in. Unplug from outlet when not in use and
before servicing.
Do not use outdoor or in wet surfaces.
Do not allow to be used as a toy. Close attention is necessary when used by
or near children.
Use only as described in this manual. Use only manufacturer's recommended
attachments.
Do not use with damaged cord or plug. If appliance is not working as it should,
has been dropped, damaged, left outdoors, or dropped into water, return it to a
service center.
Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull
cord around sharp edges or corners. Do not run appliance over cord. Keep cord
away from heated surfaces.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
Do not handle plug or appliance with wet hands.
Do not put any object into openings. Do not use with any opening blocked; keep
free of dust, lint, hair, and anything that may reduce air flow.
Keep hair, loose clothing, fingers, and all parts of body away from openings and
moving parts.
Turn off all controls before unplugging.
Use extra care when cleaning on stairs.
Do not use to pick up flammable or combustible liquids, such as gasoline, or use
in areas where they may be present.
Do not pick up anything that is burning or smoking, such as cigarettes, matches,
or hot ashes.
Do not use without dust bag and/or filters in place.
Hold plug when rewinding onto cord reel. Do not allow plug to whip when
rewinding.
SAVE THESE INSTRUCTIONS.
POLARIZED PLUG (120V Models Only)
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of
electric shock, this plug will fit in a polarized outlet only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify
the plug in any way
.
Note: If the power supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person in order to avoid a hazard.
VC2000Pub1000001239 7/9/04 9:19 AM Page 2