Filter
Top Products
Attaching the steam head - Fig. D
• Slide the bottom end of the steam mop body
(12) onto the steam head (5) until it clicks
into place.
• The steam head can be removed from the
steam mop body by pressing the steam head
release button (13) and pulling the steam
mop body (12) off the steam head (5).
Attaching a cleaning pad - Fig. E
(Cleaning pad quantity varies by model)
• Place a micro-fiber cleaning pad (6) on the
floor with the ʻhook & loopʼ side facing up.
• Raise the steam mop off the resting mat (7)
and press it down onto the cleaning pad (6).
You are now ready to steam clean and
sanitize your floor.
NOTICE: Always place the steam mop on
the resting mat (7) with the handle (4) in the
upright position when stationary and make
sure the steam mop is turned off when not in
use.
Removing a cleaning pad - Fig. F
CAUTION:
Always wear suitable shoes
when changing the cleaning pad on your
steam mop. Do not wear slippers or
open-toed footwear.
• Return the handle (4) to the upright position
and turn the steam mop ʻOFFʼ.
• Place the steam mop on the resting mat and
wait until it cools down. (approximately five
minutes)
• Place the front of your shoe onto the
cleaning pad removal tab (13) and press
down firmly.
• Lift the steam mop up off the cleaning pad.
NOTICE: Always place the steam mop on
the resting mat (7) with the handle (4) in the
upright position when stationary and make
sure the steam mop is turned off when not in use.
Filling the water tank - Fig. G, H, I
NOTE: Fill the water tank with regular tap water.
NOTE: In areas of very hard water, the use of
de-ionized water is recommended.
• Ensure that the appliance is switched off
and the power cord is disconnected from the
power outlet.
• Place the steam mop on the resting mat (7)
with the handle (4) in the upright position.
• Remove the filler cap (15) by turning it
counterclockwise.
5
D
5
12
13
E
6
F
13
G
15