Filter
Top Products
Features
• 3000W
• 3-Heat settings
• Wheels
How to use your Radiator
Caution: This product is intended for heating rooms. Do not use this appliance for any other purpose. For
indoor, domestic use only.
Assembly:
• Fit the wheels before using the appliance. Never use the appliance without the wheels fitted.
• Fit a wheel into a wheel support (6) making sure to align the flat portions of each item. Fit a washer over the
threaded portion of the wheel, then fit the nut & tighten it. Repeat for the other wheel then repeat the
process to assemble the other wheel support.
• Place the heater on the floor upside down. It is quite normal to hear the oil moving inside the radiator.
• Holding the bent end, insert the wheel clamp (7) between the last 2 heating fins. Place one assembled
wheel support over this, & fit the bent end of the clamp through the hole in the support.
• Slide the wheel support towards the bend in the wheel clamp, rotating the clamp as it moves until the free
end can be fitted through the other hole.
• Tighten the wing nut onto the free end of the clamp.
• Repeat this assembly process for the other wheel assembly.
Note: When fully assembled, the 2 sets of wheels should be facing away from each other (wheels out). Put
the heater into its normal upright position. Wait for at least three minutes before operating the appliance.
-4-
Fit nut &
tighten
Place clamp
over radiator
Locate bend
in support…
…with wheels “out”
Locate free end of support
Fit wing
nut (11)
Finished
item
Align flats & fit wheel
Fit washer
OR7B 1500W, OR9B 2000W, OR11B 2500W