Filter
Top Products
32
OPERATING PROCEDURE PHOTOS
1. Removing the cabinet
(1) Remove the screw fixing the service panel. (See
Photo 1.)
(2) Pull down the service panel and remove it. (See Photo
1.)
(3) Remove the screws fixing the conduit cover. (See
Photo 2.)
(4) Remove the conduit cover. (See Photo 2.)
(5) Disconnect the power supply wire and indoor/outdoor
connecting wire.
(6) Remove the screws fixing the top panel. (See Photo 1.)
(7) Remove the top panel. (See Photo 1.)
(8) Remove the screws fixing the cabinet.
(9) Remove the cabinet.
(10)
Remove the screws fixing the back panel.
(11)
Remove the back panel.
32
11
DISASSEMBLY INSTRUCTIONS
(1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with this connector has the
locking mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Hold the sleeve, and
pull out the terminal
slowly.
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
<"Terminal with locking mechanism" Detaching points>
Connector
Sleeve
Locking lever
11-1. MUZ-FD09NA MUZ-FD12NA
NOTE : Turn OFF power supply before disassembling.
Photo 1
Screws of
the cabinet
Back
panel
Service
panel
Screws of
the top panel
Screw of the
cabinet
Screws
of the top
panel
Hooks
Photo 2
Screw of the
conduit cover
Conduit plate
Screw of
the service
panel
Conduit cover