Black & Decker HX280 Fan User Manual


 
Fan Operation:
Fully unwind the cord & place the unit on the floor, away from any obstructions and pointing towards the
area of the room to be cooled.
Rotate the heating selector (3) to the Fan setting, and rotate the thermostat dial (1) to maximum.
Connect the appliance to a suitable electrical supply.
The power lamp (2) will illuminate & cool air will be blown into the room.
Note that the fan will cycle on and off if the thermostat dial (1) is set at a lower temperature.
During operation, the “power on” (2) lamp will only be lit when the fan is running.
When it is no longer necessary to cool the room, rotate the heating selector (3) to setting “0” to switch the
unit off and unplug it from the mains supply.
Note: This unit must be attended in use.
Warning: In order to avoid overheating, do not cover this appliance.
Safety Fuse
In case of overheating, a cut-out will operate and the appliance will stop working. If the appliance stops
operating, turn the heating selector (3) to 0, unplug the appliance and allow it to cool for at least 10 minutes
before attempting to use it again.
In extreme conditions, a back-up cut-out will operate. This will not re-set & the appliance will need to be
repaired by a qualified person.
Note: This appliance is fitted with a safety device which will prevent the heater working unless it is in its
normal, upright working position.
How to take care of your Fan Heater
Cleaning your Fan Heater
Switch off the appliance before cleaning, changing accessories or approaching parts which move in use.
Do not immerse the appliance, cord set or plug in liquids
Wipe the appliance with a damp cloth & dry thoroughly before using.
Additional Safety Warnings:
Do not use this heater with a programmer, timer or any other device that switches the heater on
automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
Combustible materials such as furniture, pillows, bedding, papers, clothes and curtains must be kept at
least 1m from the front of the appliance.
Do not allow anything to block the vents at the rear of the appliance. A gap of at least 15cm is advised.
Always use and store in a dry area.
Do not use in areas where gas, paint or other flammable goods may be present.
-5-