Filter
Top Products
8
ENGLISH
(Original instructions)
Note:
head to the steam head.
delta head clicks into place.
Caution! Always place the steam mop on the resting mat (8)
with the handle (4) in the upright position when stationary and
make sure the steam mop is turned off when not in use.
Filling the water tank (Fig. H)
The watertank on your steam mop is removable for convi-
This Steam Mop incorporates an anti-calc system to help
prolong the life of the system.
Note: Fill the water tank with clean tap water.
Note: In areas of very hard water, the use of de-ionised water
is recommended.
Remove the water tank (3).
(20).
Fill the water tank (3) with water.
Warning! Your water tank has a 0.5 litre capacity. Do not over
Note:
Use
Important! This unit will kill 99.9% of bacteria & germs when
Switching on and off
To switch the appliance on, press the ON/OFF button (1).
It takes approximately 15 seconds for the steam mop to
heat up.
Note: -
ervoir will glow red. Once the steam mop is ready to use the
water reservoir will glow blue.
To switch the appliance off, press the ON/OFF button (1).
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop on
the resting mat (8) with the handle (4) in the upright position
when stationary and make sure the steam mop is turned off
when not in use.
Caution! Always empty the steam mop after use.
Smartselect
TM
Technology (Fig. J)
TM
button (2)
which shows various cleaning applications. They are used to
select the correct operating mode for your particular cleaning
operation.
Using Smartselect
TM
, choose from one of the following applic-
ations by pressing the smartselect button (2) until the required
setting is selected:
Wood/Laminate
Stone/Marble
Tiles/Vinyl
The steam mop will select the correct volume of steam
required for your particular cleaning operation.
Note: Always check you are using the correct setting before
using your steam mop. For convienience the steam mop will
remember the last setting you chose.
Steam burst (Fig. I)
The steam mop is equipped with a steam bust button to aid in
the removal of stubborn marks and stains.
During use, press the steam bust button (21) to apply
extra cleaning power.
Note: The stem burst will last for 10 seconds then the stem
mop will return to the chosen setting.
Hints for optimum use
General
Caution!
cleaning pad.
During use you can use the cable mamagement clip (11)
to keep your cable out of the way of the work area..
mop.
The easiest way to use the machine is to tilt the handle to
a 45˚ angle and clean slowly, covering a small area at a
time.
Do not use chemical cleaners with your steam mop. To
can use the steam burst button to apply extra steam to
the area or pre-treat with a mild detergent and some water
before using the steam mop.
Smartselect