Filter
Top Products
6
• Figure I - While holding the dust bowl over a
wastebasket or sink, pull out the filter to empty
the contents of the bowl.
• Figure J - Empty the dust from the bowl and
wash if necessary.
• Figure K - The dust bowl can also be washed
in warm soapy water. Wash the filter regularly
using warm, soapy water and ensure that it is
completely dry before using it again. The cleaner
the filter is, the better the product will perform.
• Ensure that the dust bowl and filter is dry before
re-attaching.
• It is very important that the filter is correctly in
position before use.
IMPORTANT: Maximum dust collection will only
be obtained with a clean filter and an empty dust
bowl. If dust begins to fall back out of the product
after it is switched off, this indicates that the bowl
is full and requires emptying.
Replacing the lters
The filters should be replaced every 6 to 9 months and whenever worn or damaged.
Replacement filters are available from your Black & Decker dealer.
Visit www.blackanddecker.com to locate dealers.
• Remove the old filters as described above.
• Fit the new filters as described above.
Maintenance
Bowls and filters can be washed thoroughly; however, use only mild soap and a damp
cloth to clean the main part of the vacuum.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement
parts.
I
J
K