Filter
Top Products
INSTALLATION INSTRUCTIONS (FIG. B)
Fix the charging base within reach of an electrical outlet, using the screws supplied. Plug in
and place the product in position. Always mount in an upright (handle up) position.
NOTE: Avoid damaging the cord while fixing the base to the wall or when removing or
replacing the product from the base.
RECHARGING (FIG. C)
The charger supplied with this product is intended to be plugged in such that it is correctly
orientated in a vertical or floor mount position.
From new, the rechargeable cells of the product need a minimum charge time of 16 hours
to ensure full power. While charging the charge indicator light will be illuminated. The switch
must be in the off (“O”) position. The product will not charge if it is in any other position.
While charging, the product may get warm, this is perfectly normal and safe. It can remain
on charge indefinitely without damage or danger. It is not possible to “overcharge” the
battery cells with the charger provided.
Before recharging unit, make sure extension nozzle (from figure J) is retracted back in to
bowl of the unit.
THIS PRODUCT IS FOR DRY PICK-UP ONLY.
OPERATION
Ensure that the product is fully engaged on the charging base and the charge indicator light
is on.
SWITCHING ON AND OFF (FIG. D)
To start, slide the On/Off switch forward (i.e. “O”= Off, “I” = On). To stop, slide the switch
back.
Always return the product to the charging base immediately after use so that it will be
ready and fully charged for the next use. Ensure that the product is fully engaged on the
charging base.
CLEANING THE PRODUCT (FIGS . E-I)
WARNING: Never use the Dustbuster without its filters.
NOTE: The filters are re-usable, do not confuse them with disposable dust bags, and do
not throw them away when the product is emptied. We recommend that you replace the
filters every 6-9 months depending on frequency of use. See ”ACCESSORIES” for filter
catalog numbers.
FIG. E - Remove the dust bowl by pressing the dust bowl release button and pulling the
bowl down and out. To replace the bowl, place it back onto the handle and click firmly into
position. Important: For best vacuum results, empty bowl after every use.
FIG. F - Empty the debris from the bowl and wash if necessary (see Fig. H).
FILTERS
NOTE: CHV9608 uses a single filter
. CHV1408, CHV1568 and CHV1688 use an inner
and outer filter
.
FIG. G - To remove the filter(s) twist the outer (plastic) filter in a clockwise direction. Shake
or lightly brush any loose dust off the outer filter.
FIG. G1 - CHV1408, CHV1568 and CHV1688 only
.
Remove the inner filter and shake, tap
or lightly brush outside surface to remove loose dust. Both filters can be rinsed as shown in
fig. (H). CAUTION: Filter must be dry before re-assembling. Ensure both filters are in
place before operating.
FIG. G2 - If your unit is equipped with a filter cleaning slider as shown in Fig. G2 you can
achieve more use between filter cleanings by first switching off the vac, and then sliding the
cleaning wheel up and down as shown. Make two full cycles for best results.
FIG. H - Wash the filters using warm, soapy water and ensure that they are completely dry
before using it again. The cleaner the filters are, the better the product will perform. It is
very important that the filter is correctly in position before use. The dust bowl can also be
washed in warm soapy water. CAUTION: Filters must be dry before re-assembling.
IMPORTANT: Maximum dust collection will only be obtained with clean filters and an empty
dust bowl. If dust begins to fall back out of the product after it is switched off, this indicates
that the bowl is full and requires emptying.
FIG. I - Never immerse the product in water. A damp cloth and soapy water should be
used to clean the exterior of the motor section. Always ensure the product is completely
dry before re-use or storing.
ECONOMIC USAGE
• Your product is very economical to charge. While it is charging it uses less electricity than
a typical night light bulb.
• When fully charged and with a clean filter, the average effective usage times vary by
voltage.
7.2 volts: 7 - 9 minutes 9.6-12 volts: 9-11 minutes
14.0 volts and higher: 12-15 minutes
TROUBLE SHOOTING
If the product does not work, check the following:
• That the charge indicator light is on when unit is in base.
• The charger was correctly plugged in for recharge. ( It feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly attached to the base.
• The charger is plugged into a working electrical outlet.
• That the switch is in the “OFF” position when charging.
ACCESSORIES
A crevice tool is built-in to the nozzle and can be extended as shown in figure J by pulling
the extension piece until it locks into position.
The extension can be retracted by depressing the arrow button at the back of the extension
and pushing the extension back into the nozzle. Additional accessories are stored on the
product (FIG. K) and are fitted into the nose of the product for use. NOTE: CVHV9608
includes brush only. Accessory use is shown in FIG. L.
Note: Replacement filters can be purchased from most local/national retailers that
sell vacuums, or by calling 1-888-678-7278.
Look for:
VF96 filter for catalog number CHV9608
VF08 filters for catalog numbers CHV1408 and CHV1568
VF08H HEPA filter for CHV1688.
BATTERY REMOVAL AND DISPOSAL FIGURE M
This product uses nickel-cadmium (Ni-Cd) rechargeable and recyclable batteries. When
the batteries no longer hold a charge, they should be removed from the Vac and recycled.
They must not be incinerated or composted.
The batteries can be taken for disposal to a Black & Decker, Company-Owned or
Authorized Service Center. Some local retailers are also participating in a national
recycling program (see “RBRC
TM
Seal”). Call your local retailer for details. If you bring the
batteries to a Black & Decker Company-Owned or Authorized Service Center, the Center
will arrange to recycle old batteries. Or, contact your local municipality for proper disposal
instructions in your city/town.
To remove the battery pack for disposal:
1) Unlatch bowl from main handle unit.
2) Remove filter(s).
3) Remove the seven screws holding the unit together.
4) Pull the cover half away from the location half.
5a) For catalog number CHV9608, lift out the full motor/fan/battery assembly.
5b) For catalog numbers CHV1468, CHV1568, CHV1688 prise small cover from filter
cleaning slider and remove slider securing screw.
- lift out the full motor/fan/battery assembly
6) Unplug battery assembly from main assembly.
To replace or obtain a new battery pack, contact your local Black & Decker, Company-
Owned or Authorized Service Center, or call 1-800-544-6986. Be prepared to provide the
Catalog No. of your DustBuster, found on the housing.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never let any liquid get inside the vac;
never immerse any part of the vac into a liquid.
NOTE: Make sure the vacuum is completely dry before using it.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service organizations, always using identical replacement
parts.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the nickel-
cadmium battery (or battery pack) indicates that the costs to recycle the battery
(or battery pack) at the end of its useful life have already been paid by Black &
Decker. In some areas, it is illegal to place spent nickel-cadmium batteries in the
trash or municipal solid waste stream and the RBRC program provides an environmentally
conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent nickel-
cadmium batteries. Help protect our environment and conserve natural resources by
returning the spent nickel-cadmium battery to an authorized Black & Decker service center
or to your local retailer for recycling. You may also contact your local recycling center for
information on where to drop off the spent battery, or call 1-800-8-BATTERY.
SERVICE INFORMATION
All Black & Decker Service Centers are staffed with trained personnel to provide customers
with efficient and reliable power tool service. Whether you need technical advice, repair, or
genuine factory replacement parts, contact the Black & Decker location nearest you. To find
your local service location, refer to the yellow page directory under "Tools—Electric" or call:
1-800-544-6986 or visit www.blackanddecker.com
FULL TWO-YEAR HOME USE WARRANTY
Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material
or workmanship. The defective product will be replaced or repaired at no charge in either of
two ways.
The first, which will result in exchanges only, is to return the product to the retailer from
whom it was purchased (provided that the store is a participating retailer). Returns should be
made within the time period of the retailer’s policy for exchanges (usually 30 to 90 days after
the sale). Proof of purchase may be required. Please check with the retailer for their specific
return policy regarding returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or
authorized Service Center for repair or replacement at our option. Proof of purchase may be
required.Black & Decker owned and authorized Service Centers are listed under
"Tools-Electric" in the yellow pages of the phone directory.
This warranty does not apply to accessories. This warranty gives you specific legal rights
and you may have other rights which vary from state to state or province to province. Should
you have any questions, contact the manager of your nearest Black & Decker Service
Center. This product is not intended for commercial use.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are
missing, call 1-800-544-6986 for a free replacement.
See ‘Tools-Electric’
– Yellow Pages –
for Service & Sales
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
How To Use
Product Features (Fig. A)
1. On/Off slide switch 4. Wall mountable charging base 7. Filter cleaning slider
2. Bowl release button 5. Charger
3. Dust bowl 6. Charge indicator light
CONSERVER CE MODE D’EMPLOI POUR UN USAGE ULTÉRIEUR.
POUR UN USAGE DOMESTIQUE UNIQUEMENT.
Pour l´achat d´un filtre de rechange
composer le 1-888-678-7278.
N° de catalogue
CHV9608, CHV1408, CHV1568, CHV1688
MODE D’EMPLOI
AVANT DE RETOURNER CE PRODUIT POUR QUELQUE
RAISON QUE CE SOIT, COMPOSER LE
1-800-544-6986
AVANT D’APPELER, AYEZ EN MAIN LE N° DE CATALOGUE ET LE CODE DE DATE. DANS LAPLUPART DES
CAS, UN REPRÉSENTANT DE BLACK & DECKER PEUT RÉSOUDRE LE PROBLÈME PAR
TÉLÉPHONE. SI VOUS AVEZ UNE SUGGESTION OU UN COMMENTAIRE, APPELEZ-NOUS. VOS
IMPRESSIONS SONT CRUCIALES POUR BLACK & DECKER.
M
M
ERCI
ERCI
D
D
’
’
A
A
VOIR
VOIR
CHOISI
CHOISI
B
B
LACK
LACK
& D
& D
ECKER
ECKER
!
!
V
V
ISITEZ
ISITEZ
WWW
WWW
.B
.B
LACKAND
LACKAND
D
D
ECKER
ECKER
.
.
COM
COM
/N
/N
EW
EW
O
O
WNER
WNER
POUR
POUR
ENREGISTRER
ENREGISTRER
VOTRE
VOTRE
NOUVEAU
NOUVEAU
PRODUIT
PRODUIT
.
.
IMPORTANTES MISES EN GARDE
Lorsqu’on utilise un appareil électrique, il faut toujours respecter certaines règles de sécurité
fondamentales, notamment les suivantes.
LIRE ET COMPRENDRE TOUTES LES DIRECTIVES AVANT D’UTILISER L’APPAREIL.
LIGNES DIRECTRICES EN MATIÈRE DE SÉCURITÉ - DÉFINITIONS
Il est important que vous lisiez et compreniez ce mode d’emploi. Les informations qu’il con-
tient concernent VOTRE SÉCURITÉ et visent à ÉVITER TOUT PROBLÈME. Les symboles
ci-dessous servent à vous aider à reconnaître cette information.
DANGER : Indique une situation dangereuse imminente qui, si elle n’est pas évitée,
causera la mort ou des graves blessures.
AVERTISSEMENT : Indique une situation potentiellement
dangereuse qui, si elle n’est pas évitée, pourrait causer la mort ou de graves blessures.
MISE EN GARDE : Indique une situation potentiellement dangereuse
qui, si elle n’est pas évitée, pourrait causer des blessures mineures ou modérées.
MISE EN GARDE : Utilisé sans le symbole d’alerte à la sécurité, indique une
situation potentiellement dangereuse qui, si elle n’est pas évitée, peut résulter en des dommages
à la propriété.
AVERTISSEMENT : Certaines poussières domestiques con-
tiennent des produits chimiques reconnus par l’État de la Californie comme étant can-
cérogènes et pouvant entraîner des anomalies congénitales et d’autres risques pour la
reproduction tels que l’amiante et le plomb contenu dans les peintures au plomb.
AVERTISSEMENT : Afin de minimiser les risques d’in-
cendie, de secousses électriques ou de blessures.
• Exercer une étroite surveillance lorsqu’on utilise l’appareil près d’un enfant ou que l’appareil
est utilisé par ce dernier. Il ne s’agit pas d’un jouet.