Filter
Top Products
7
• Release the pivot lock trigger (3) to lock the vac in any of the three different
working positions (figures E,F & G).
• Figure H illustrates a typical application of vacuuming under furniture and other
hard to reach places.
OPERATION
• Before first use, the battery must be charged for at least 21 hours.
• Place the appliance on the charging base (6) whenever it is not in use.
CHARGING THE BATTERY (FIGURE I)
• Make sure that the appliance is switched off.
The battery will not be charged with the on/off switch (4) in the on position.
• Place the appliance on the charging base as shown.
• Plug in the charger.
The charging indicator (5) will be lit.
• Leave the appliance to charge for at least 21 hours.
SAFETY WARNINGS AND INSTRUCTIONS: CHARGING
• While charging, the charger may become warm. This is normal and does not indicate a
problem.
• The appliance can be left connected to the charger indefinitely. The charging indicator
(5) will be lit as long as the appliance is connected to the plugged-in charger.
• Do not charge the battery at ambient temperatures below 39° F (4 °C) or above 104°
(40 °C).
SWITCHING ON AND OFF (FIGURE J)
• To switch the appliance on, slide the on/off switch (4) forward to the 1st position
(vacuum only).
• For vacuuming with beater bar operation slide the on/off switch forward to the 2nd
position.
• To switch the appliance off, slide the on/off switch back.
CLEANING AND MAINTENANCE
CAUTION: Regularly clean the filters (9 & 10).
CLEANING THE DUST CONTAINER AND FILTERS (FIGURES K - N)
The filters are re-usable and should be cleaned regularly.
• Press the release latch (1) and open the container door (2) (figure K).
• Remove the filters (9 & 10) (figures L & M).
• Empty the dust container.
• Brush any loose dust off the filters.
• Wash the filters in warm, soapy water.
• Make sure that the filters are dry.
A section (11) of the unit can be removed to aid cleaning should the product become
blocked resulting in a loss of suction (figure N).
• Remove the section using a flat bladed screwdriver (figure N inset) to release the
front clip features.
Once released, the section will pivot free of the main assembly to give access for
cleaning.
• Never immerse the product in water. A damp cloth and soapy water should be used
to clean the exterior of the motor section. Always ensure the product is completely dry
before re-use or storing.
ACCESSORIES
To purchase replacement filters call 1-888-678-7278.
ECONOMIC USAGE
• Your product is very economical to charge. While it is charging it uses less than half
the amount of electricity used by a common night light.
• When fully charged, the average effective usage times are between 10-12 minutes
with brush on (carpet), 12-14 minutes with brush on (hard floor) and 14-16 minutes
with vac only.
• It may take several chargings before these times can be achieved.
90528647 01 PSV1800 PIVOT CRDL VAC 10/16/08 7:47 AM Page 7