Filter
Top Products
12
WARNING: Do not brush or use compressed air to clean the filter.
• Depending on its condition, rinse the outside of the filter with water. Allow the filter to
dry for 24 hours before reinserting it.
WARNING: Do not wash the inside of the filter.
• Replace the filter.
• Re-fit the pre-filter.
• Close the lower door.
• Re-insert the container into the appliance.
Cleaning the motor filter (fig. H & L)
The motor filter (35) prevents particles and larger objects from entering the motor
housing when the container is removed.
The filter (35) is re-usable and should be cleaned regularly.
• Remove the container from the appliance (fig. H).
• Take the filter (35) out (fig. L).
• Brush any loose dust off the filter.
• Replace the filter (35).
• Re-insert the container into the appliance.
Replacing the filters
If the container filter (34) is damaged or fails to operate properly, it must be replaced.
Replacement filters are available from your Black & Decker dealer (cat. no. VLF50).
For information regarding Replacement Filters please call 1-800-544-6986.
Replacing the container filter
• Proceed as described above to replace the filter (34).
Replacing the outlet filter (fig. M & N)
The appliance is fitted with a lifetime filter but if it is required to be replaced, replace it
as follows:
• Remove the two screws (36)
• Remove the cover (37) by using a tool to lift the cover up.
• Remove the old filter (38) by pulling it out.
• Insert the new filter as shown.
• Refit the cover with the two screws (36).
IMPORTANT: UNPLUG VACUUM BEFORE PERFORMING ANY MAINTENANCE.
Use only mild soap and a damp cloth to clean your vacuum. Never let any liquid get
inside the vacuum; never immerse any part of the vacuum into a liquid.
Note: Make sure the vacuum is completely dry before using it.
Your Black & Decker appliance has been designed to operate over a long period of time
with a minimum of maintenance. Continuous satisfactory operation depends upon
proper appliance care and regular cleaning.
WARNING: Before performing any maintenance or cleaning on the
appliance, unplug the appliance.
• Regularly clean the ventilation slots in your appliance using a soft brush or dry cloth.
• Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
Replacement Parts
90518824 CAN. CANNISTER VAC 10/28/08 10:40 AM Page 12