Filter
Top Products
How to Use
This appliance is intended for household use only.
Important: For warranty verification, do not remove line cord sticker.
The Advanced Safety Technology™ (AST) system features unique technology built
into your heater that offers protection detailed in the "Special Features" section.
Before Use:
Important:
During the first few minutes of initial use, you may notice a slight odor. This is
normal and will quickly disappear. This heater is intended for use on a flat, stable
surface, such as a floor, tabletop, shelf, or desk in a location where the airflow
grille openings won’t be obstructed. Do not use in wet or moist locations, like
bathrooms or laundry areas, or in areas where paint or other flammable or
volatile liquids are used or stored.
Caution: Be sure no other appliances are plugged into same circuit with
heater/fan. A circuit overload could occur.
1. Place heater on a flat, stable surface, such as a floor or tabletop where airflow
grille opening won’t be obstructed. Use fold-down handle when moving unit.
Do not use in wet/moist locations, like bathrooms or laundry areas, or in areas
where paint, flammable, or other volatile liquids are used or stored.
2. Be sure control knob is in the OFF position, then plug heater into a standard
AC outlet.
3. Room Select: Turn switch to the appropriate setting
for a small (approx. 10' x 10'/3 m x 3 m), medium
(approx. 12'x12'/3.8 m x 3.8 m) or large (approx.
12'x 16'/3.8m x 5m) room (B)
4. Turn thermostat control to HOT to activate heater. Once
desired room temperature is achieved, lower thermostat
control toward FROST WATCH until unit cycles off.
The thermostat will cycle unit on and off to maintain your comfortable
temperature level.
5. Turn timer knob to the 1 hr., 2 hr., 3 hr. or 4 hr. setting to select how long
you’d like heater to stay on. The unit will shut off automatically once the
selected time runs out. To operate heater continuously, turn timer knob to ON.
Remember to shut unit Off when done.
6. To use as a fan without heat, move control knob to FAN ONLY and thermostat
control toward HOT until fan begins to operate. No heating will occur in this
mode.
7. To turn off, turn thermostat control to FROST WATCH and control knob to Off.
Note: The power indicator light shows heater is on and operating. It continues to
glow even if thermostat has cycled off and heating elements are off.
8. Frost Watch: When heater is plugged in and POWER indicator light is on,
you can select any setting for room size (depending on your model) and leave
thermostat control on toward lower settings or FROST WATCH. Heater will
remain off unless the temperature drops below (40° F/4°C). If this happens,
FROST WATCH will automatically cycle unit on to protect against freezing
pipes or frost damage.
4
3
Product may vary slightly from what is illustrated.
1. Fold-down handle
2. Timer knob
3. Control knob
4. CAUTION indicator
5. Heat sensor patch
6. Front grille
7. Roll-over bars
8. Power indicator
9. Thermostat control
·
»
³
¿
ᕧ
ᕦ
ᕨ
ᕩ
´
B
200UHPub1000002035 4/15/05 1:53 PM Page 4