Filter
Top Products
www.bissell.com 800.237.7691
7
Operations
1A
1B
Getting ready
The mop pad may have already
come attached to the mop head, if
not follow steps 1A and 1B below.
1. Attach mop pad
A. Set mop head in mop pad, making
sure toggle is located on the back.
B. Tighten mop pad by pulling on elastic
cord while pressing on toggle.
2. Fill the water tank
A. Remove tank by lifting straight up
and away from unit.
B. Unscrew cap at bottom of water tank.
C. Fill water tank with water. For best
results, water should be at
room temperature.
D. Replace the cap, tighten until snug.
E. Replace water tank by gently sliding
tank into place.
3. Twist the quick release cord wrap clock-
wise to unwrap the power cord com-
pletely and plug into a 120-Volt outlet
as described on the Important Safety
Instructions, page 3.
4. The indicator light will illuminate when the
Steam Mop Select is plugged in.
NOTE: Upon first use of the Steam
Mop Select or first use after refilling
the water tank, the pump may make
a "knocking" sound. This is normal
and should only last a few seconds.
While in use, the pump will continue
to make a soft "knocking" sound.
This is also normal.
2A
2D
2B
2E
Tip:
Use of distilled water is recommend-
ed to prolong the life of your Steam
Mop Select