Filter
Top Products
When you are done using your BISSELL CleanView, return it to the
Upright position and store the Power Cord.
Turn vacuum cleaner off.
Unplug Power Cord by grasping the polarized plug (NOT the
cord) and disconnect from outlet.
Loop Power Cord around Cord Wraps on side of
vacuum cleaner.
Clip molded plug to Power Cord to secure.
To maintain maximum cleaning performance, the following
maintenance steps must be performed:
Empty the Dirt Container when the dirt reaches the “Full” line
on the side.
Clean or replace the Pre-Motor Filter at least once a month.
Clean or replace the Post-Motor Filter every 3 months.
More frequent filter cleaning may be necessary if you are vacuuming
new carpet, fine dust, or have allergy concerns. Follow the instructions
on the following pages to perform these simple maintenance steps.
The Dirt Container needs to be emptied when the dirt reaches the Full
line on the side of the Container.
Unplug cleaner from electrical outlet.
Slide the Lock ‘n Seal Lever to the "Unlock" position.
Grasp handle and pull the Dirt Container straight out to remove
from vacuum.
Empty dirt into garbage container.
Put the Dirt Container back in the vacuum and slide the lever to
the "Lock" position.
Note: The Dirt Container may be washed in warm
water with a mild detergent. Make sure it is
completely dry before using again.
How to Maintain Your BISSELL CleanView
®
Tip:
For maximum
cleaning performance,
Check and clean or
replace all filters
as suggested.
WARNING: To
reduce the risk of electric
shock, turn Power Switch
OFF and disconnect
polarized plug from
electrical outlet before
performing maintenance or
troubleshooting checks.
Power Cord Storage
1.
2.
3.
4.
NOTICE:
While vacuuming, certain
carpets and low humidity
conditions may generate small
static discharges. The discharges
are entirely harmless and are
not associated in any way with
the main power supply.
Empty Dirt Container
1.
2.
3.
1.
2.
3.
4.
5.
Full Line
Lock Position
Unlock
Position
8