Filter
Top Products
SmartMix
bottle
ON
O
F
F
6
Special Features of your BISSELL ProHeat
®
Pro-Tech
®
The ProHeat Pro-Tech is a home cleaning system that automatically
mixes hot tap water with Fiber Cleansing Formula and heats the
solution as it is applied to the carpet. The combination of heated
cleaning solution, powered brush and suction provide a safe and
effective method of cleaning.
Temperature control automatically heats the cleaning solution
as it is being applied to the carpet (*) to safely optimize
cleaning effectiveness.
The Power Switch controls power to the machine; both
switches must be ON for SmartTemp to work.
The SmartTemp Switch is found on the back of the handle
next to the Power Switch. You may choose not to use the
SmartTemp feature if you are cleaning delicate wool or
oriental rugs.
*SmartTemp heats the cleaning solution for carpet
and bare floor application only. It does not heat
solution sprayed through the accessory tools.
The SmartTemp Ready Light indicates when the heater is
ON. The heater should be turned on two minutes before
cleaning, to become fully warmed up and ready to clean. It
is found on the front of the handle where it is easy to see
while you clean.
SmartTemp increases the water temperature approximately
25° and will not allow it to exceed 180.°
Provides custom control for each cleaning job.
Lift the SmartMix concentrate bottle up and out of the
machine base.
Turn the bottle over so that the valve cap is in an upward
position. Unscrew the valve cap and fill the bottle to the
mark with BISSELL Fiber Cleansing Formula.
Replace the valve cap turning until snug.
SmartTemp
®
1.
2.
3.
4.
Power Switch
SmartTemp
Switch
ON
OFF
SmartTemp Ready Light
The BISSELL SmartClean
®
System
SmartMix
®
1.
2.
3.